Aquasana AQ-UV-10C Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Sistemi di filtrazione dell'acqua Aquasana AQ-UV-10C. Aquasana AQ-UV-10C 20. Whole house uv filter
Anche per Aquasana AQ-UV-10C: Istruzioni per il funzionamento e l'installazione (16 pagine)

Stampa la pagina

Add Gland Nut and Compression Spring

1. Hand tighten the Gland Nut over the Quartz

Sleeve onto the threaded end of the UV Reactor.

NOTE: DO NOT use tools for this step. It has

a positive stop to prevent over-tightening.

2. Insert the Compression Spring into the Quartz Sleeve.

NOTE: DO NOT install a UV Lamp inside the

Quartz Sleeve without the Compression

Spring in place.

Check For Leaks

When all plumbing connections have been completed, and you've allowed

proper time for glue to dry according to manufacturer instructions, slowly

turn on the water supply and check for leaks. Make sure the bypass valves

are functioning properly and that the water is flowing through the

UV Reactor.

Troubleshooting: The most common leak is from the O-Ring not making a

proper seal on the UV Reactor. For new installations, review steps 5 and 6.

If you experience leaks during this step while replacing your UV Lamp, drain

the UV Reactor, remove the O-Ring, dry it, and reapply silicon grease. Reinstall

the O-Ring ensuring that it is properly sealed against the UV Reactor and check

again for leaks.

Mount Controller

Mount the Controller to the wall above

the UV Reactor.

NOTE: Ensure that no moisture can

deposit on any of the connections.

Always mount the Controller vertically.

NOTE: DO NOT plug the Controller

power cord in before the last step.

INSTALLATION STEPS