AQUASCAN INTERNATIONAL CSE Series Manuale - Pagina 7

Sfoglia online o scarica il pdf Manuale per Cercatore di pesci AQUASCAN INTERNATIONAL CSE Series. AQUASCAN INTERNATIONAL CSE Series 20.

Error messages:

RUB WINDOW Cx

SUNLIGHT Cx

CAL FAIL Cx

Cx: yyy Cerr

POWER LOST!

NO SPEED Cx

LENS PROBLEM Cx

REG.KOM ERR Cx

LOST Cx

Cx: yyy LOST

OVERRUN Cx

x may be 1,2,3 or 4. The counting is stopped for this channel. Clean all

surfaces between the light- source and sensor in the referred Registration

Unit. Then press the corresponding Cx key.

x may be 1,2,3 or 4. This is a warning, the counting is not stopped. Make

sure that the view of the lenses are not exposed to sunlight.

Then press the corresponding Cx key.

x may be 1,2,3 or 4. The Calibration was not correctly performed. A press

on the belonging channel button will view the number calculated.

Stop counting (N/S key). Restart and do a new calibration for this channel.

x may be 1,2,3 or 4, yyy is number. The calibration was not performed

correct, but the error was accepted. Press Stop

calibration for this channel.

Power disappeared during previous counting (not stopped with the 0/Stop

key). Press Enter to restart. When screen shows WEIGHT(g) Cx,

press Enter to resume counting.

x may be 1,2,3 or 4. This is a warning, counting is not stopped. The speed

calculations in the Registration Unit are having a problem.

This may be caused by too much water in a dry-counter, too much air in a

fullwater- counter, or dirt on the transparent pipe.

x may be 1,2,3 or 4. This is a warning, counting is not stopped. The lens at

the out-side is seeing dirt.

x may be 1,2,3 or 4. This is a warning, counting is not stopped. The

Control Unit receives incorrect data from the Registration Unit. This may be

caused by a faulty Unit (Registration Unit, Control Unit or cable), or

disturbance from external equipment.

x may be 1,2,3 or 4. The Control Unit does no longer receive data from the

Registration Unit.

x may be 1,2,3 or 4, yyy is number. The Control Unit does no longer receive

data from the Registration Unit, and the error was accepted.

x may be 1,2,3 or 4. The counting is stopped for Cx. The counting data

could not be processed fast enough and data has been lost.

Page 7 of 20

and make a new

(0/Stop)