Diamond 330 Manuale di uso e manutenzione - Pagina 6

Sfoglia online o scarica il pdf Manuale di uso e manutenzione per Elettrodomestici da cucina Diamond 330. Diamond 330 16. Ce professional slicer

2.3 - ELECTRICAL CONNECTION

Check that the specifications provided

in the rating plate -serial number (Fig.

n°17) and in the consignment and deliv-

ery documents, correspond; if not con-

tact the supplier immediately.

Check power supply cable and slicer

earthing .

The slicer is fitted with a power supply cable having a cross section of 3x1mm²;

approximate length 1.5m and a "SHUKO" plug. Connect the 230 V - 50 Hz sli-

cer, interposing a 10 A I= 0.03A thermomagnetic differential switch.

The slicer is fitted with a power supply cable having a cross section area of

5x1mm², approximate length 1.5m and a red 15A 3F + T CEI plug. Connect the

slicer to the 400 V - 50Hz three-phase supply mains, interposing a 10 A I=

0.03A thermomagnetic differential switch.

The slicer is fitted with a power supply cable having a cross section area of

5x1mm², approximate length 1.5m and a blue 15A 3F + T CEI plug. Connect the

slicer to the 230 V - 50Hz three-phase supply mains, interposing a 10 A I=

0.03A thermomagnetic differential switch.

Check blade rotation is anti-clockwise looking at the slicer from bladeguard side.

If not proceed as in 2.3.4 .

Check the direction of the blade

rotation with a pulse of the "I" push-

button (ON), immediately followed by

the "0" push-button OFF.

The direction of the blade rotation

must be counter-clockwise when loo-

king at the slicer from the bladeguard

side (Fig. n°18). In the case that the

rotation direction is not exact, invert

Fig. n°17

Fig. n°18

(Fig. n°19) the position of two of the

three phase wires (black, gray or

brown) in the plug.

Fig. n°19

Fig. n°20