AquaScape AQUAFORCE 4000-8000 Istruzioni e manutenzione - Pagina 8
Sfoglia online o scarica il pdf Istruzioni e manutenzione per Pompa dell'acqua AquaScape AQUAFORCE 4000-8000. AquaScape AQUAFORCE 4000-8000 20. Remote-controlled submersible, solids-handling waterfall & filter pump
Anche per AquaScape AQUAFORCE 4000-8000: Istruzioni e manutenzione (9 pagine)
Winter Application
• If running through winter conditions, check regularly to make sure it is functioning properly and ice is not preventing water
from reaching the pump. In the event of a power failure, the pump should be removed to prevent any freeze damage to the
pump or the piping.
• If concerned about possible freeze damage, disconnect and remove the pump. Be careful not to lose the flat rubber washer.
Clean with fresh water and store the pump in a frost-free location. If needed, use Aquascape Pump Cleaner Maintenance
Solution (#91143) to remove excessive buildup.
Troubleshooting
• Reduced water flow
– The pump or plumbing may be clogged
∙ Make sure nothing is blocking the intake
∙ Clean the outer cage
∙ Clean the impeller rotor assembly and internal pump body
• Pump hums but doesn't push water
– The pump or plumbing may be clogged
∙ Make sure nothing is blocking the intake
∙ Clean the outer cage
∙ Clean the impeller rotor assembly and internal pump body
– Make sure the pump is receiving the correct voltage
– Make sure the impeller blades are not worn or damaged
• Pump not working
– Ground-fault circuit interrupter (GFCI) may have tripped
– The pump is not receiving the correct voltage
• Device won't pair
– Make sure the outlet is receiving power
– Make sure you have adequate wireless coverage to connect the device
– Reset the device to factory defaults
– Make sure the ground-fault circuit interrupter (GFCI) is not tripped
8
☎
☎
US (866) 877-6637 |
CAN (866) 766-3426 | aquascapeinc.com