Diamond CB425A Manuale di istruzioni per l'installazione, l'uso e la manutenzione - Pagina 14

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione, l'uso e la manutenzione per Fabbricatore di ghiaccio Diamond CB425A. Diamond CB425A 15. Automatic ice - cube maker

Stampa la pagina

shown in Figure 18. Remove the side plugs and

clean the bank under running water.

To clean the internal basin, slide out the overflow

pipe (41) (see Fig. 18). The water that remains will

drain off automatically. Use a sponge to remove any

sediment that may have collected on the bottom of

the basin, and clean the basin.

Remove the stainless steel pump return filter/s, as

shown in Figure 18, and clean under running water.

In addition to the foregoing operations, clean the

ice tray.

Fit all parts back in place, complying with the

demounting instructions in reverse order.

For cleaning, use an ordinary dish-washing

detergent or a solution of water and vinegar. To eli-

minate scaling, use a soft plastic-bristle brush and

a sponge.

Avoid using abrasive detergent or powders, which

may damage the finish.

To obtain a sanitizing effect, repeat the above

cleaning operations using a suitable solution, such

as one of those used for disinfecting baby feeding

bottles.

When the cleaning and/or sanitizing operations

have been completed, rinse the parts thoroughly

with plenty of cold water and eliminate any ice

that may have been produced during the initial

cycles.

Complete sanitizing can only be carried out only

by the Authorized Technical Service Centers,

and must be done regularly depending on the

conditions of use of the appliance, the chemical

and physical features of the water, and after

every period in which the appliance has

remained at a standstill for any length of time.

You are advised to ask your dealer to draw up a

scheduled maintenance contract that will cover

the following:

•

cleaning the condenser

•

cleaning the filter located on the water inlet

solenoid valve

•

cleaning the ice-tray

•

checking the charge of coolant gas

•

checking the operating cycle

•

sanitizing the appliance.

10 PERIODS AT A STANDSTILL

If you do not intend to use the appliance for a certain

period of time, proceed as follows:

Switch off the electric power source by means

of the switch fitted during installation, and

remove the plug of the appliance from its socket.

Shut off the water supply by turning off the tap

fitted during installation.

Carry out all the operations envisaged for

scheduled maintenance of the appliance.

Empty out the pump body by blowing

compressed air into the pipe that supplies water

(43) to the sprayer bank.

The Manufacturer declines all liability for any

inaccuracies in this Instruction Manual due to

printing or transcription errors. The Manufacturer

also reserves the right to make any modifications to

the products that may be necessary or useful, also

in the interests of the user, without impairing the

products' essential features of functionality and

safety.