AquaScape AQUAFORCE 4000-8000 Istruzioni e manutenzione - Pagina 6
Sfoglia online o scarica il pdf Istruzioni e manutenzione per Pompe per laghetti AquaScape AQUAFORCE 4000-8000. AquaScape AQUAFORCE 4000-8000 20. Remote-controlled submersible, solids-handling waterfall & filter pump
Anche per AquaScape AQUAFORCE 4000-8000: Istruzioni e manutenzione (9 pagine)
Stampa la pagina
Ex. 9
NOTE: Adequate Wi-Fi coverage is required (2.4g
networks supported).
• Continue to follow on-screen instructions to complete the
pairing process.
• To reset the device to factory defaults, first turn the unit off
by pressing the power button, then press and hold the +
and - buttons for four seconds and release when the LED
display lights up completely (Ex. 13).
• The receiver includes a switch that allows the pump to be
operated in the two following modes (Ex. 14).
General Maintenance
• It is recommended to inspect your pump on a regular
basis to make sure it is functioning properly.
NOTE: Always disconnect the power before performing
maintenance on the pump.
Pump Cage Cleaning
• A pump cage clogged with debris will reduce the water
flow rate.
6
Ex. 10
Ex. 11
Position 1 - Operated by Aquascape Smart Control
O
App or remote control
Position 2 - Bypass control, and operate at full
–
flow-rate
• In the event of a power loss the pump will revert to the last
flow-rate setting.
Using the AquaForce as a Winter Bubbler
• The AquaForce can also be used to prevent winter fish loss
by keeping a hole open in the ice during the cold winter
Ex. 12
months. The AquaForce helps ensure there is sufficient
oxygen levels and proper gas exchange in the pond.
• For best results use the
AquaForce in combination
with a de-icer (Ex. 15).
The combination of
the AquaForce and a
de-icer will increase
the oxygen levels and
remove potentially harmful
gases from the water.
• Do not place the
AquaForce on the bottom of the pond during the winter,
which may disrupt the natural thermocline in the deeper
portions of the pond where the fish overwinter. Instead,
place the pump at least one foot above the deepest point
of the pond. The rotational ball should be turned upwards,
allowing the water to bubble at the surface of the pond.
Bricks or stones can be used, if needed, to raise the pump
Ex. 13
to the proper level.
Ex. 14
• Remove any existing debris
from the outside of the
cage (Ex. 16).
Impeller/Rotor Cleaning
• In situations with excess
debris build-up, the cage
will need to be removed for
a more thorough cleaning.
☎
☎
US (866) 877-6637 |
Pond De-Icer (#39000)
CAN (866) 766-3426 | aquascapeinc.com
Ex. 15
Ex. 16