Diamond Antenna K9000 Istruzioni per l'uso - Pagina 4

Sfoglia online o scarica il pdf Istruzioni per l'uso per Automobile Accessories Diamond Antenna K9000. Diamond Antenna K9000 4. Motor drive mount

Power Cord Wiring

• Attach wires from control box and motor drive mount.

A positive voltage is applied on both power cords. If power cords

are forced unreasonably or pinched, the fuse may blow due to the

short.

• Wire the connector of the control box to the connector of the

mount bracket. Insert cigar plug.

0.8A Fuse

located in cigar

plug

* Using fuse greater than 0.5 Amp may cause damage to mount.

Operating Angle Adjustment

• Mount the antenna before making angle adjustment. Turning of

the adjust knob during antenna's down position may cause dam-

age to the limit switch.

* Operating angle at shipment is set at 45 degrees.

Set antenna to be raised to 90 degrees by operating the control switch.

• Fasten screws after adjusted.

This product was manufactured under strict quality control,

if damage occurred during shipping, contact your dealer.

Design and specifications of this product are subject to change

without notice.

Specifications

Antenna Length to be Installed

Antenna Weight to be Installed

Operating Voltage

Operating Current

Operating Time

Operating Angles

Fuse Capacity

Loosen the nut (side of antenna

mount) and set antenna for vertical

position.

Adjust knob by using coin in

coingroove.

45" maximum

1 lb. maximum

13.8 V (10-16 V)

less than 0.4 A

about 4 seconds (0-90°)

45-90 degrees

0.8 A