DIAMOND DATA CD-ROM DRIVES Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Unità CD/CDR DIAMOND DATA CD-ROM DRIVES. DIAMOND DATA CD-ROM DRIVES 4. Ide/atapi interface cd-rom drive models

Stampa la pagina

Installation

Hardware Installation

Please follow those steps to install the CD-ROM drive:

1. Turn off the computer and all peripheral devices, and

disconnect the computer's power cord.

2. Remove the computer housing or casing. Place the CD-

ROM drive in a 5.25-inch bay.

3. Secure the drive into the half-height drive bay using four

screws.

4. Connect the 4-pin drive power cable and 40-pin IOE

interface cable. The coloured edge of the lDE cable must

be aligned with the Pin 1 position.

5. Re-install the computer housing or casing.

6. Reconnect the computer power cord, and turn the

computer on.

Software Installation

For Windows 95, 98, NT or OS/2 Warp, no external device

driver is needed. For DOS and Windows 3.1, the installation

procedure is as follows:

1. Turn on your computer and boot to MS-DOS.

2. Insert the CD-ROM Device Driver disk into a 3.5" floppy

disk drive.

3. At the command prompt, type the drive letter of the floppy

DIAMOND DATA CD-ROM DRIVES

Mitsubishi Electric Australia

disk drive that you are using, followed by a colon (:) and

then press Enter.

4. Type Setup, and then press Enter.

5. Follow the instructions on the screen.

6. You can choose Express Setup or Custom Setup. It Is

recommended that you use Express Setup.

7. Reboot your system.

NOTE: Please read the README file in the device driver disk

to learn more about using this drive.

Emergency Eject

If for any reason be tray does not eject automatically, insert a

straightened paper clip or similar object into the emergency

eject hole to manually eject the tray. The length of the

straightened section should be approximately 50 mm.

Be sure to turn the power to the computer off before manually

ejecting a disc.

User's Guide