3Built RES12VLAB Manuale di istruzioni per l'installazione

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Telecomando 3Built RES12VLAB. 3Built RES12VLAB 9. Remote engine shut-off

Stampa la pagina

INSTALLATION INSTRUCTIONS

WARNING

BY INSTALLING OR USING THIS PRODUCT YOU AGREE TO OUR "END USER AGREEMENT". IT IS INCLUDED WITH

THESE INSTRUCTIONS AND AVAILABLE ON-LINE AT http://www.3built.com/documents.asp

Use of this product could result in injuries and/or property damage due to the sudden loss of engine power. Vehicles may lose

stability when engine power is disabled. Control of the vehicle will also be limited after engine is disabled. This product will not stop

a vehicle. It will not apply the brakes or any other mechanism to reduce speed. It is designed to disable the engine by shutting off the

ignition system. It functions similarly to the vehicle's stock ignition ON/OFF switch. Use extreme caution as to when and where the

vehicle is before disabling the engine. Proper judgment must be used when disabling engine power. Performance and range is not

guaranteed. Radio frequency interference may be common in some areas and can affect this product's range and performance. Use

of motor vehicles is an inherently dangerous activity. Wear proper protective gear when operating the vehicle. If any doubt of

potential injury, do not use. Once installed, to understand how this product functions, test the device by disabling the vehicle's engine,

first at idle and then at low speed. This product's installation and use is at your own risk. This product is intended to be installed and

used by adults only.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired

operation.

INCLUDED PARTS

Lane

Switch

GETTING STARTED

All radio transmissions are susceptible to interference from many sources.

loss of communication between the Transmitter and Receiver. Resistor spark plugs and suppression type spark plug wires may

reduce radio interference.

2) Do not connect any RES wire to the high voltage spark plug wire.

3) If connecting to magneto, use additional solenoid. (see Super-Mag installation sheet.)

4) Installation of this device requires electrical and electronics knowledge.

5) You should have a wiring diagram for your vehicle before installation. This is available from your dealer in the Repair Manual for

your vehicle. Some vehicle specific wiring instructions are available on our website at: http://www.3built.com/pages/support

6) This device is a remotely activated switch. The switch can be connected as a normally-open or normally-closed switch while the

vehicle is in the RUN mode. The internal relay is limited to switching 8 amperes, maximum.

7) It is important to determine your OEM (original equipment manufacturer) RUN/STOP switch type before installation. Improper

installation of this unit can damage your vehicle's electrical system and CDI. If unsure, please consult a professional.

(1) Receiver

(1) Transmitter

Power

Switch

Receiver

Remote Engine Shut-Off

(1) USB Cable (1) USB Charger

Interference can cause reduced range or complete

9/30/19

RES12VLAB

Transmitter

Firmware ver:6.1.19