HP 1410-24G-R Manuale introduttivo - Pagina 5
Sfoglia online o scarica il pdf Manuale introduttivo per Interruttore HP 1410-24G-R. HP 1410-24G-R 21. 1410 switch series
Anche per HP 1410-24G-R: Specifiche (33 pagine), Specifiche (33 pagine), Manuale di configurazione rapida (2 pagine)
Stampa la pagina
Preparing for installation
Safety recommendations
WARNING!
Before installation and operation, read all of the safety instructions in the
supplied with your device.
Safety symbols
When reading this document, note the following symbols:
WARNING means an alert that calls attention to important information that if not understood or
followed can result in personal injury.
CAUTION means an alert that calls attention to important information that if not understood or
followed can result in data loss, data corruption, or damage to hardware or software.
General safety recommendations
To avoid any equipment damage or bodily injury caused by improper use, read the following safety
recommendations before installation. Note that the recommendations do not cover every possible
hazardous condition.
Do not place the switch on an unstable case or desk. The switch might be severely damaged in case
•
of a fall.
•
Make sure the ground is dry and flat and anti-slip measures are in place.
Keep the chassis and installation tools away from walk areas.
•
Keep the chassis clean and dust-free.
•
Do not place the switch near water or place it in a damp environment. Prevent water or moisture
•
from entering the switch chassis.
To prevent condensation, unpack the switch at least half an hour after you move the switch from a
•
location below 0°C (32°F) to the equipment room. Power on the switch at least 2 hours after you
move the switch from a location below 0°C (32°F) to the equipment room.
Ensure proper ventilation of the equipment room, and keep the air inlet and outlet vents of the switch
•
free of obstruction.
Make sure the operating voltage is in the required range.
•
Use a screw driver to fasten screws.
•
2
Compliance and Safety Guide