HP ProCurve 6120G/XG Istruzioni per l'installazione - Pagina 3
Sfoglia online o scarica il pdf Istruzioni per l'installazione per Interruttore HP ProCurve 6120G/XG. HP ProCurve 6120G/XG 4. Ethernet blade switch
Anche per HP ProCurve 6120G/XG: Istruzioni per l'installazione (4 pagine), Domande frequenti (4 pagine), Opuscolo e specifiche (17 pagine)
Stampa la pagina
Installing the HP ProCurve 6120XG
Blade Switch
If there is only one blade switch in the chassis, it must occupy a slot
on the left-hand side of the chassis (as you face the back of the
chassis). If there is more than one blade switch in the chassis, the
configuration rules can be somewhat complex; refer to the
Installation and Getting Started Guide for the blade switch for more
detail.
Follow these steps to install a blade switch module in your chassis:
NOTE: The HP ProCurve 6120XG Blade Switch module
can be used in an HP BladeSystem c7000 Enclosure or an
HP BladeSystem c3000 Enclosure. The illustrations in this
document show the blade switch being installed in a
c7000 enclosure.
1.
Remove the interconnect blank.
2.
Prepare the HP ProCurve 6120XG Blade Switch for
installation.
3.
Install the blade switch into the interconnect bay.
A green Module Status ("health") LED indicates a
successful installation. If the Module Status LED is amber
or is off, see the "Troubleshooting" section of the HP
BladeSystem enclosure setup and installation guide for
more information.
4.
Connect network cables to the blade switch as desired.
Accessing the blade switch from
the HP BladeSystem Onboard
Administrator
These instructions assume that you have already set up the HP
BladeSystem Onboard Administrator (OA) using the First Time Setup
Wizard. See the HP BladeSystem Onboard Administrator User
Guide for details on OA setup. For information on OA command line
interface (CLI) commands, see the HP BladeSystem Onboard
Administrator Command Line Interface User Guide. Both guides are
available at http://www.hp.com/go/bladesystem/documentation.
1.
Connect a workstation or laptop computer to the serial port
on the c3000/c7000 OA module using a null-modem
serial cable (RS-232).
2.
Using a terminal program (such as HyperTerminal or
TeraTerm), open a connection to the serial port using
connection parameters of 9600, 8, N, 1.
3.
Press Enter. OA prompts you for login information.
4.
Enter a valid username and password. The OA system
prompt appears.
5.
Enter the command:
connect interconnect <bay_number>
where <bay_number> is the number of the bay
containing the blade switch. OA connects you to the
initial screen of the blade switch CLI.
6.
Press Enter. The blade switch CLI prompt appears. You
are now ready to enter blade switch CLI commands.
See the paragraphs below for instructions for assigning an IP
address to the blade switch. Refer to the Management and
Configuration Guide for HP ProCurve 6120 Blade Switches for more