HP StorageWorks 2/140 - Director Switch Manuale di istruzioni per l'installazione - Pagina 17

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Interruttore HP StorageWorks 2/140 - Director Switch. HP StorageWorks 2/140 - Director Switch 22. Director power cord advisory instruction
Anche per HP StorageWorks 2/140 - Director Switch: Nota di rilascio (27 pagine), Nota di rilascio (24 pagine), Nota di rilascio (20 pagine), Nota di rilascio (13 pagine), Nota di rilascio (11 pagine), Nota di rilascio (10 pagine), Istruzioni (1 pagine)

Stampa la pagina

HP StorageWorks 2/140 - Director Switch Manuale di istruzioni per l'installazione

Installing Shelf Brackets in an HP Rack System/e or 19-inch

EIA Rack

The shelf brackets mount directly to the interior vertical rails of the HP rack system/e

or 19-inch EIA rack using cage nuts and Phillips panhead screws.

Use these steps to install the two shelf brackets in an HP rack system/e or 19-inch EIA

rack.

1. Determine the appropriate placement for the Director inside the rack.

NOTE: HP strongly recommends installing the Director 2/140 in the lowest position in the rack.

2. Along an exterior vertical rail of the rack cabinet, determine the position of the

bottom of the shelf bracket and count 1 U up from this location.

3. Use a straight edge to locate the corresponding rack holes along the interior

vertical rails of the rack cabinet. Mark this location on each interior vertical rail.

4. Install two cage nuts along one interior vertical rail as marked in

one empty rack hole between the cage nuts.

5. Repeat

step 4

6. Secure a shelf bracket to the interior vertical rails using four (4) Phillips panhead

screws with split lock and flat washers.

7. Repeat

step 6

8. Continue to

director 2/140 rack mount kit installation instructions

for each of the three remaining interior vertical rails.

to secure the second shelf bracket on the opposite side of the rack.

"Attaching the Mounting Hardware to the Director

Installation Instructions

step

3, leaving

2/140" on page 8.