HP StorageWorks 2/140 - Director Switch Manuale di istruzioni per l'installazione - Pagina 20

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Interruttore HP StorageWorks 2/140 - Director Switch. HP StorageWorks 2/140 - Director Switch 22. Director power cord advisory instruction
Anche per HP StorageWorks 2/140 - Director Switch: Nota di rilascio (27 pagine), Nota di rilascio (24 pagine), Nota di rilascio (20 pagine), Nota di rilascio (13 pagine), Nota di rilascio (11 pagine), Nota di rilascio (10 pagine), Istruzioni (1 pagine)

Stampa la pagina

HP StorageWorks 2/140 - Director Switch Manuale di istruzioni per l'installazione

Installation Instructions

Installing the Director 2/140 in the Rack

Use these steps to maneuver the Director 2/140 into the rack:

1. Using a lift device, position the Director 2/140 at the front of the cabinet.

2. If necessary, adjust the lift height so that the bottom of the Director 2/140 is

parallel with the shelf mounts in the rack.

3. Slide the Director along the shelf mounts and into the cabinet until the front

mounting brackets on the Director 2/140 contact the front cabinet rails.

Securing the Front Mounting Brackets to the Rack

Follow this procedure to secure the front mounting brackets attached to the Director

2/140 to the rack:

1. Secure one of the front mounting brackets to a cabinet rail by attaching three

Phillips panhead screws to the cage nuts you installed earlier.

2. Repeat

step 1

rail.

Securing the Rear Mounting Brackets to the Rack

Follow this procedure to attach the Director 2/140 rear mounting plates to the rack

using the rear mounting bracket:

1. Align a rear mounting bracket with the cage nuts you installed earlier, and the

screw holes in the rear mounting plate attached to the Director 2/140.

2. Attach a rear mounting bracket to a rear mounting plate by installing three Phillips

panhead screws in the mounting plate holes. Do not tighten.

3. Adjust the position of the rear bracket so that the holes align with the cage nuts

installed in the cabinet rail.

4. Attach the rear mounting bracket to the cage nuts installed in the cabinet rail using

three Phillips panhead screws. Tighten securely.

5. Tighten the screws attached to the rear mounting plate.

6. Repeat

step 1

rear rail.

to secure the other front mounting bracket to the remaining cabinet

through

step 5

to attach a rear mounting bracket to the remaining

director 2/140 rack mount kit installation instructions