HP StorageWorks 2/8q FC Avvio rapido - Pagina 2

Sfoglia online o scarica il pdf Avvio rapido per Interruttore HP StorageWorks 2/8q FC. HP StorageWorks 2/8q FC 2. Fibre channel switch

Stampa la pagina

Step 3: Mount the switch

For a surface mount:

Obtain the rubber feet from the switch carton and attach the

feet to the bottom of the switch. Then, place the switch on a

stable work surface.

For a rack mount:

Note:

This switch is mounted from the rear of the rack.

1. Obtain the 2U rack template and 2U rail kit from the

MSA1000 SAN Kit carton, and the switch mounting

adapter brackets and screws from the switch carton.

2. Use the template to mark the holes on the front and back of

the rack, to indicate the location for the rails.

3. From the rear of the rack, install the rails by inserting the

left rail (marked L) into the inside-left rear of the rack, until

the pins extend through the holes marked in step 2 and the

scissor-type locking latch engages. Then, extend the other

end of the rail toward the inside front of the rack until the

pins extend through the marked holes. Loosen the locking

nut on the retaining bracket and slide the bracket to the

farthest position near the front of rack. Repeat these steps to

install the other rail.

4. Fasten the mounting adapter brackets to the switch, with

the port side of the switch facing the flanges of the adapter

brackets. Position the brackets so that the switch is set back

approximately 3 inches from the flanges.

5. From the rear of the rack, slide the switch assembly onto

the previously installed rails, until the flanges of the

mounting brackets are flush with the rear uprights of the

rack.

6. Secure the switch to the rack by securing the provided

screws through the flanges to the rear of the rack, and then,

from the front of the rack, slide the retaining brackets on

the rail towards the switch, until they engage the switch.

Then tighten the thumbscrews on the retaining bracket.

Step 4: Install the SFPs

1. Obtain the SFPs.

Four SFPs are included in the switch shipping carton;

additional SFPs may be purchased separately.

2. Insert an SFP into a Fibre Channel port.

Push the SFP into the port with gentle pressure until the

SFP snaps into place.

Note:

An SFP fits only one way in the Fibre Channel port. If the SFP

does not install under gentle pressure, pull it out of the port, turn it

over, and re-insert it.

Step 5: Connect the cables

1. Connect a Fibre Channel cable between each SFP installed

in the switch and its corresponding device.

2. Attach the power cable between the switch and the power

source.

— Verify that the Input Power LED (green) is illuminated.

— Wait a few minutes for the self test to complete.

— Verify that the Heartbeat LED is blinking (once per

second) and the System Fault LED (amber) is NOT

illuminated.

Physical installation of your new switch is complete.

Step 6: Configure the switch

The 2/8q FC Switch, the HBA in the server, and the storage in

the MSA are configured using tools provided in the MSA1000

Small Business SAN Kit carton.

Obtain the MSA1000 Small Business SAN Kit Installation

Instructions from the MSA1000 SAN Kit carton, and follow

the instructions on the poster to prepare and configure the

devices.

For additional information about your 2/8q FC Switch, refer to

the switch documents provided on the MSA1000 SAN Kit

Documentation CD, including the Installation Guide,

Management User Guide, Release Notes, and Readme

information.

Page 2