HP StorageWorks 7110 - Virtual Array Istruzioni per l'aggiornamento - Pagina 6

Sfoglia online o scarica il pdf Istruzioni per l'aggiornamento per Interruttore HP StorageWorks 7110 - Virtual Array. HP StorageWorks 7110 - Virtual Array 12. Private loop (hubs/direct connect)
Anche per HP StorageWorks 7110 - Virtual Array: Utilizzo del manuale (34 pagine), Istruzioni (4 pagine), Manuale (4 pagine), Manuale (4 pagine), Istruzioni per l'installazione (2 pagine), Manuale (2 pagine), Manuale (1 pagine), Manuale (1 pagine)

Stampa la pagina
HP StorageWorks 7110 - Virtual Array Istruzioni per l'aggiornamento
Upgrade Disk Firmware
Power Off the Array
6
Upgrading a VA 7100/7400 to a VA 7410/7110
1
Save the state of the array:
armdsp <array_id> > armdsp_<array_id>
armdsp -a <array_id> > armdsp_a_<array_id>
2
Save a list of any feature licenses that are installed:
armfeature -r <array_id> > armfeature_<array_id>
3
If the host port behavior table is being used, save the table:
armhost -r -f armhost_<array_id>.txt <array_id>
If the Secure Manager LUN security table is being used, save the table:
4
armsecure -r -f armsecure_<array_id>.txt -p password
<array_id>
The VA 7410/7110 uses a 2 Gbit back-end. All disks that will be used in the
upgraded array must have firmware that supports the 2 Gbit transfer speed.
The upgrading of disk firmware is described in a Service Note available on the
following internal HP web site:
http://snserver.mayfield.hp.com/products/A6183A/
When upgrading to a VA 7410/7110, it is best to avoid an image disk
conflict. This occurs when the VA 7410/7110 controllers find a valid image
from a VA 7100 or VA 7400 during power on. Because the images are
incompatible, an abterm error will occur if a valid image disk is found.
To avoid this situation, the array enclosure must be powered off without
performing a shutdown. This ensures that the image disks on the array are
invalid. When the VA 7410/7110 controllers are powered on, they will not
find a valid image and an image conflict (and the resulting abterm) will not
occur.
Simultaneously disconnect both power cords from the array controller
1
enclosure.
2
Set the array controller enclosure power/standby switch to the OFF
position.
3
Power down any disk enclosures.