HP StorageWorks 8B - FC Entry Switch Manuale di istruzioni per l'installazione - Pagina 17

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Interruttore HP StorageWorks 8B - FC Entry Switch. HP StorageWorks 8B - FC Entry Switch 20. Fabric os release notes version 3.0.1b
Anche per HP StorageWorks 8B - FC Entry Switch: Manuale di aggiornamento (9 pagine), Manuale d'uso (22 pagine), Note di rilascio del firmware (14 pagine), Manuale di installazione (14 pagine), Nota di rilascio (26 pagine), Manuale (50 pagine), Manuale d'uso (44 pagine), Manuale d'uso (44 pagine), Manuale d'uso (38 pagine), Manuale d'uso (38 pagine), Manuale d'uso (37 pagine), Manuale d'uso (30 pagine), Nota di rilascio (16 pagine)

Note:

is installed in the HP System/e rack. The plenum is not needed if the switch is installed

in an HP 9000 Series or comparable EIA rack.

Verify that the plenum (part number A7346-00001) is preinstalled on the SAN Switch

2/8 before proceeding. The plenum is required for the SAN Switch 2/8 rack mount

only, as it allows air to dissipate at the rear of the rack, preventing overheating.

If the plenum is not preinstalled on the SAN Switch 2/8, refer to the

SAN Switch 2/8 Version 3.1.x Installation Guide

instructions.

Figure 8: Assembling the inner rails on a SAN Switch 2/8 with plenum

SAN Switch Rack Mount Kit Installation Instructions

b. For the SAN Switch 2/8, assemble the two inner rails (one on each side)

to the switch and plenum using the appropriate number (from

#8-32 x 3/16-inch Phillips pan-head screws as shown in

The plenum is only a required part of this installation when the SAN Switch 2/8

Figure

HP StorageWorks

for complete plenum installation

step

5) of