HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM Manuale di istruzioni per l'installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Interruttore HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM. HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM 20. 1u rackmount tape enclosure
Anche per HP STORAGEWORKS ALL-IN-ONE STORAGE SYSTEM: Istruzioni per l'installazione (2 pagine), Manuale di installazione (14 pagine), Nota di rilascio (14 pagine), Istruzioni per l'installazione (2 pagine), Manuale di riferimento (46 pagine)

Installation and Safety Guidelines

Read the following sections for installation guidelines. Install the SAN Switch in

one of the following ways:

To ensure correct operation of the switch, the location where the switch is in use

must meet the following requirements:

Cooling air is drawn into the switch chassis by the fans mounted on the rear of the

chassis. The air is expelled through vents in the front (port side) of the chassis,

next to the HP logo. HP recommends installing the switch so that air intake and

exhaust for all components in the rack is flowing in the same front-to-back

direction.

Note:

reside in the front of the cabinet, and the ports (cables) reside in the rear of the cabinet.

SAN Switch Rack Mount Kit Installation Instructions

As a stand-alone unit on a flat surface.

In an Electronics Industries Association (EIA) cabinet (like the HP 9000

Series Rack).

In an HP System/e rack.

Adequate supply circuit, line fusing, and wire size, as specified by the

electrical rating on the switch nameplate.

An air flow of at least 300 cubic feet per minute, available in the immediate

vicinity of the switch.

If installing the switch in the HP 9000 Series, or comparable EIA rack:

— All equipment installed in the rack should have a reliable branch circuit

ground connection, and should not rely on a connection to a branch

circuit, such as a power strip.

— The rack should be balanced and the installed equipment should be within

the rack's weight limits. Ensure the rack is mechanically secured to insure

stability in the event of an earthquake.

HP highly recommends mounting the switch in a cabinet or rack so that the fans