HP StorageWorks XP10000 - Disk Array Manuale di configurazione - Pagina 9

SNMP configuration

The XP family of disk arrays and the SVS 200 support standard Simple Network Management Protocol

(SNMP) for remotely managing arrays. The SNMP agent on the service processor (SVP) performs

error-reporting operations requested by the SNMP manager. SNMP properties are usually set from

the SVP but they can also be set remotely using XP Remote Web Console or XP Command View

Advanced Edition Software. Refer to the applicable user's guide for procedures.

Figure 1 SNMP configuration

Perform these actions to install and configure the disk array:

Setting the host mode and host group mode

Setting the System Option Modes

Configuring the Fibre Channel ports

Install and configure the host

Loading the operating system and software

Installing and configuring the FCSAs

Fabric zoning and LUN security

Connect the disk array

Defining the paths

Verifying disk array device recognition

Configure disk devices

Installing and configuring the disk array

The HP service representative performs these tasks:

Assembling hardware and installing software

Loading the microcode updates

Installing and formatting devices

After these tasks are finished, you will use XP Remote Web Console, XP Command View Advanced

Edition Software, or XP Array Manager to complete the remaining tasks listed below. If you do not

have these programs, your HP service representative can perform these tasks for you.

XP Disk Array Configuration Guide for NonStop