HP StorageWorks XP10000 - Disk Array Manuale di configurazione - Pagina 16

Figure 3 Direct attach without a SAN example

Table 2 Fabric topology settings

Fabric Parameter

OFF

Installing and configuring the host

This section explains how to install and configure the host and Fibre Channel ServerNet Adapters

(FCSAs) that connect the host to the disk array.

Follow the manufacturer's instructions to load the operating system and software onto the host. Load

all OS patches and configuration utilities supported by HP.

Install and configure the adapters using the Fibre Channel ServerNet Adapter Installation and Support

Guide, available at the NonStop Technical Library website:

http://h30163.www3.hp.com/ntl/.

You can connect multiple clusters of various operating systems to the same switch using appropriate

switch zoning and array LUN security as follows:

•

Use Secure Manager for LUN isolation when multiple NonStop systems connect through a shared

array port. Secure Manager provides LUN security by allowing you to restrict which LUNs each

host can access.

Installing and configuring NonStop for the XP disk array

Connection Parameter

FC-AL

Point-to-Point

FC-AL

Point-to-Point

Provides

Not supported

N-port (SAN fabric port)

NL-port (private arbitrated loop; direct connect without a

SAN)

Not supported