HP StorageWorks XP12000 Manuale di configurazione - Pagina 15

Installing and configuring the host

This section explains how to install and configure Fibre Channel adapters (FCAs) that connect the

host to the disk array.

Follow the manufacturer's instructions to load the operating system and software onto the host. Load

all OS patches and configuration utilities supported by HP and the FCA manufacturer.

Install and configure the Fibre Channel adapters using the FCA manufacturer's instructions.

Verify FCA installation and set fabric mode by using wwidmgr:

P00 >>> set mode diagnostic (AlphaServer 8x00/GS60E only)

P00 >>> wwidmgr -show adapter

The list of adapters is displayed.

Example

P00>>>wwidmgr -show adapter

item

[ 0]

[ 1]

[9999] All of the above.

P00 >>> wwidmgr -set adapter -item xxxx -topology fabric (where -item

xxxx is the item number of the desired FCA taken from the list generated in step 2)

This sets the FCA for the required fabric mode.

NOTE:

An item number of 9999 sets the specified topology on all FCAs in the system.

Example

P00>>>wwidmgr -set adapter -item 1 -topo fabric

adapter

pga0.0.0.4.6

1000-0000-c920-05ab

pgb0.0.0.8.6

1000-0000-c921-0ce0

WWN

XP Disk Array Configuration Guide for OpenVMS

Cur. Topo

Next Topo

FABRIC

LOOP