HP StorageWorks XP12000 Manuale di configurazione del sistema - Pagina 28

Error Condition

Physical volumes cannot be created.

Logical volumes cannot be created.

A ﬁle system is not mounted after rebooting.

The disk array performs a self reboot

because the disk array was busy or it

logged a panic message.

The disk array responds "Not Ready" or the

disk array has displayed "Not Ready" and

timed out.

The host detects a parity error.

The host hangs or devices are declared and

the host hangs.

Calling the HP support center

If you are unable to resolve an error condition, contact the HP support center for

assistance.

In North America, call technical support at 1-800-633-3600, available 24 hours a

day, 7 days a week.

Outside North America, call technical support at the location nearest you. Telephone

numbers for worldwide technical support are listed on the HP support web site:

http://www.hp.com/support. From this web site, select your country.

Troubleshooting

Recommended Action

Verify that the disk array logical devices are

correctly formatted.

Verify that the volume capacity for OPEN-x

volumes is not greater than the maximum

capacity allowed. See the

speciﬁcations

table.

Verify that the capacity of the volume group

is not less than the total capacity of the

partitioned logical volume.

Verify that the host was restarted correctly.

Verify that the ﬁle system attributes are

correct.

Reboot the host.

Contact HP.

Check the HBA and make sure it was

installed properly.

Reboot the host.

Make sure there are no duplicate disk array

TIDs and that disk array TIDs do not conﬂict

with any host TIDs.

Emulation