HP XP20000/XP24000 Manuale di configurazione - Pagina 23

Sfoglia online o scarica il pdf Manuale di configurazione per Interruttore HP XP20000/XP24000. HP XP20000/XP24000 42. Hp storageworks xp disk array configuration guide: vmware (a5951-96106, september 2010)
Anche per HP XP20000/XP24000: Nota di rilascio (13 pagine), Manuale di integrazione (29 pagine), Nota di rilascio (4 pagine), Manuale dell'amministratore (50 pagine), Manuale di configurazione (40 pagine), Manuale di configurazione (40 pagine), Manuale di configurazione (36 pagine), Manuale di configurazione (36 pagine), Manuale di configurazione (30 pagine), Manuale di configurazione (36 pagine), Nota di rilascio (5 pagine), Manuale di configurazione (46 pagine), Manuale di configurazione (46 pagine), Manuale di riferimento (46 pagine), Manuale di configurazione (40 pagine), Manuale di configurazione (44 pagine), Manuale di configurazione (38 pagine), Manuale di configurazione (34 pagine), Manuale di configurazione (30 pagine), Manuale di configurazione (30 pagine)

TIP:

Creating scripts to configure all devices at once may save you considerable time.

Labeling and partitioning the devices

Partition and label the new devices using the Sun format utility.

CAUTION:

The repair, analyze, defect, and verify commands/menus are not applicable to the XP arrays and

SVS 200. When selecting disk devices, be careful to select the correct disk as using the partition/label

commands on disks that have data can cause data loss.

Enter format at the root prompt to start the utility.

Verify that all new devices are displayed. If they are not, exit the format utility (quit or Ctrl-D),

and ensure port and LUN assigned was done correctly for all devices and that all new devices

were added to the driver configuration file.

Record the character-type device file names (for example, c1t2d0) for all the new disks. You will

use this data either to create the file systems or to use them with the Sun or Veritas Volume

Manager.

When you are asked to specify the disk, enter the number of the device to be labeled.

When you are asked if you want to label the disk, enter y for "yes."

If you are not using Veritas Volume Manager or Solaris Volume Manager with named disksets,

use the partition command to create or adjust the slices (partitions) as necessary.

Repeat this labeling procedure for each new device (use the disk command to select another

disk).

When you finish labeling the disks, enter quit or press Ctrl-D to exit the format utility.

For further information, see the System Administration Guide - Devices and File systems at:

http://docs.sun.com.

If you want to create a file system, create a file system of your choice on the given disks. For the

various file systems you may set specific parameters that may have an impact on performance

and are application dependant.

XP Disk Array Configuration Guide for Sun Solaris