Diamond Products CC1600 Manuale dell'operatore - Pagina 7

Sfoglia online o scarica il pdf Manuale dell'operatore per Sega Diamond Products CC1600. Diamond Products CC1600 16. Wall saw

Locate the cut line on the wall.

gas, or water lines in the area you are working. Cutting a

Locate a second line from the cut line in accordance with table 3 and place 1/2"

anchors for the track feet on this line.

Anchor Bolt Distance from

Cut Line

Locate a second line 12-1/2" from the cut line, on the side you will cut from. Place

1/2" anchors for the track feet on this line. For Longyear style feet used with non-

stiffened track, the anchor bolt should be 8-1/2" from the cut.

Thru-bolt the mounting foot on brick or concrete block walls. Use a back-up plate

if needed to ensure a secure mounting. Read and follow the safety rules and

mounting procedure provided by the anchor manufacturer.

Use leveling screws to correct for unevenness in the walls and provide stability for

the mounting feet. The head of hex head leveling screws should be against the

wall to prevent damage to the screw threads.

Mount the track on the wall with the rack on the cut side. Normally, two track feet

will be sufficient on each track section however, with the non-stiffened track, a

third foot may be needed when mounting the 90" or 122" length to reduce flexing

when using large blades or cutting difficult materials. When using stiffened track,

attach the track stop bolt into the stiffener at the top end of the track. (This acts

as a safety stop in case the track slips.)

The saw rides the track on ten rollers, six fixed and four moveable. It is guided on

the track by two fixed rollers and two adjustable slides.

Before mounting the saw, be sure the moveable rollers are in the "out" position.

Place the saw on the track with the pinion on the saw engaging the rack.

Push the moveable rollers to the "in" position to lock the saw onto the track.

Check that the saw is secure and tight. If necessary, adjust the rollers or slides as

follows:

WALL SAW SET UP INSTRUCTIONS

Before cutting or drilling, be sure there are no electric,

live wire could cause electrocution, injury or death.

Anchor Bolt Distances

Longyear Style with Non-

Chapter 3

WARNING!

Table 3

Stiffened Track

8-1/2"

All Other Styles

12-1/2"