Diamond Products CC1800XL Manuale dell'operatore - Pagina 6
Sfoglia online o scarica il pdf Manuale dell'operatore per Sega Diamond Products CC1800XL. Diamond Products CC1800XL 8. Concrete saw
Stampa la pagina
WARNING:
Over speeding the engine and
blade shaft can cause serious damage to the blade and
could result in injury to the operator and bystanders. Do
not exceed the following speeds: No load blade shaft –
2800 RPM, no load engine – 3900 RPM.
ASSEMBLY OPTIONS, OPERATOR'S PREFERENCE
1. The handles are mirror image and can be
reversed.
2. The water valve can be mounted on the left or
right side on units without the gas tank
assembly.
3. On hydraulic motor models, the hydraulic hoses
and tube assembly can be mounted on the left
or right side. If moved to the right side, the water
valve must be moved to the left side.
OPTIONAL ITEMS
HYDROSTATIC TRANSMISSION KIT
A kit is available to make the saw a self-propelled unit
with a forward and reverse ground speed of up to 70 feet
per minute. The saw can still be a push unit simply by
disengaging the transmission.
ELECTRIC WATER PUMP
A kit is available for use with electric start engine models
only. The pump is powered directly from the battery and
must be switched off when not in use or it will run until
the battery is dead.
WEIGHT KIT
Two weights are included which bolt to the front of the
saw frame. Total weight is ~26 lbs. This is standard on
all 20" models and all models over 15HP.
WATER TANK KIT
A five gallon (19Liter) tank is available for all models and
mounts to the lift bar. This option is intended for dust
suppression during dry cutting and is not sufficient for
blade cooling.
TACHOMETER / HOUR METER
A digital display meter is available for all gas models and
is standard on all 20 HP units. It is installed by simply
mounting it to the control panel and wrapping the pickup
wire around the engine spark plug wire 4 to 5 times.
BLADE SIZE
10"
12"
14"
16"
18"
20"
CONCRETE SAW OPERATING INSTRUCTIONS
MAXIMUM DEPTH
2-5/8"
3-5/8"
4-5/8"
5-5/8"
6-5/8"
7-5/8"