Diamond Tech Diamond Laser 5000 Manuale operativo - Pagina 6

Sfoglia online o scarica il pdf Manuale operativo per Sega Diamond Tech Diamond Laser 5000. Diamond Tech Diamond Laser 5000 8. Diamond laser band saw

DL5000 INSTRUCTION MANUAL

PAge 5

Quick Tips

1) When cutting, the highest blade speed will usually result in efficient and smooth cutting. Use a

slower speed when working with delicate materials or making very tight turning radius.

2) Do not force materials into the blade. ease the materials into the blade, turning as you go to

create your pattern. Keep a constant forward movement of the material through the blade as you

make your curves. avoid twisting the blade on tight curves.

3) To back out of a cut, turn the saw off and ease the material away from the blade.

4) clean band saw after each use with water. run clean water through pump until it runs clear and

the water tube appears clean. Frequent use of wD40 or similar lubricant on all screws and moving

parts is recommended.

5) when not in use, loosen blade wheel tension. when storing for extended periods, remove

blade and drive belt, then store.

6) Use a waterproof pen to mark your pattern on material. For added protection, use Chap

stick™ or candle wax over line before cutting.

7) Two or more pieces may be cut at the same time by stacking them together and using "tacky

wax", rubber cement or double-sided tape to hold material in place. if using glue or tape, clean

blade after use by running a clean piece of glass or tile through blade. it is not recommended

that you cut through thickness greater than 3/4".