Diamondback HD Manuale di installazione - Pagina 2

Sfoglia online o scarica il pdf Manuale di installazione per Automobile Accessories Diamondback HD. Diamondback HD 2. Truck cover for 2005-up toyota tacomas with the 60.3" bed
Anche per Diamondback HD: Manuale di installazione (2 pagine), Manuale di installazione (2 pagine), Manuale di installazione (2 pagine), Manuale di installazione (2 pagine)

Diamondback HD Manuale di installazione
Repeat steps 6–7 for the
8
cab panel, starting this
time with the loop-shaped
hinge knuckle on the
passenger side.
Position the cover
9
front to back so that
the leading edge of
the closed cab panel
clears the cab
window frame by
about a quarter inch.
ADJUST THE LOCK RODS
Loosen the set screws on the
12
tailgate-panel lock-rod linkages.
Adjust the length of the tailgate-panel lock rods and retighten their
13
set screws so that:
A. with the lock handle in the open position, the rod tips clear
the mounting brackets,
B. with the handle in the closed position, the rod tips do not
strike the mounting brackets, and
C. the first bend in the rods point downward.
ATTACH THE SAFETY CATCH & GAS SPRINGS
Fit the safety catch, which is
16
hanging from the driver side of
the cab panel, around the bottom
ball stud.
Attach a gas spring to the ball studs
17
alongside the safety catch.
If some of your gas springs
have heavier poundage
printed on their sides than
others, use the stronger
ones on the cab panel.
To avoid premature
failure of your gas
springs, attach them
barrel up, shaft down.
DiamondBackCovers.com
2
1
1/8" hex key
Center the cover side to side on
10
the truck.
Tighten the cap
11
clamps with a
9/16" socket.
Road vibration can loosen your clamps. Retighten them after
100 miles. Check them every time you haul on top.
With the lock handle in the
14
closed position, position the lock
rods tight against the underside
of the mounting-bracket shelf so
that they'll draw the
panels down and
compress the weath-
erstrip. Tighten the rod
guide brackets with a
7/16" socket.
To get the weatherstrip compression neces-
sary for its adhesive to cure and for the cover
to keep out the weather, have a second person
press down on the cover while you're adjusting
the lock rods.
Operating the access panels is easiest when
you press down as you open or close them.
Repeat steps 12 through 14 for
15
the cab panel.
Your panels should be difficult to operate at first. After finishing
installation below, leave the panels closed as much as possible for
3–4 days to break in the weatherstrip. After that period, you
should find that the panels open and close without difficulty.
Attach the three remaining gas springs
18
(barrel up, shaft down).
Leave the cover closed and locked for
19
24 hours to allow the weatherstrip
adhesive, which is pressure-sensitive,
to fully cure.
7/16" socket
24 hours
Adhesive cure time
MAY 2017
SEPTEMBER 2018