BIOMET SpinalPak Manuale completo e foglietto illustrativo - Pagina 6

Sfoglia online o scarica il pdf Manuale completo e foglietto illustrativo per Attrezzature per il fitness BIOMET SpinalPak. BIOMET SpinalPak 10. Non-invasive spine fusion stimulator system
Anche per BIOMET SpinalPak: Manuale del paziente (12 pagine)

Stampa la pagina

STEP 2: CHANGING BATTERY PACKS

Each day, preferably at the same time to ensure

treatment is continued without interruption, patients

should do the following:

A. Slide down the battery door on the back of the

stimulator and remove the depleted battery

(Figure 7).

B. Place the depleted battery pack into the battery

charger for charging (Figure 8). A solid orange light

on the charger will illuminate, indicating the battery

is charging. If no light appears on the charging

cradle an error is indicated. If this occurs, try

removing the battery pack from the charger and

reinserting it. If the orange light does not appear

contact Biomet.

C. Once the charger's orange light turns off and

a solid green light appears, the battery pack is fully

charged. Remove the battery pack from the battery

charger (Figure 9) and place the fully charged battery

pack into the Biomet

SpinalPak

Stimulator in order

to commence treatment.

D. There should always be one battery in the charger

and one battery installed in the stimulator at all times,

ensuring a fully charged battery every 24 hours as

recommended.

NOTE: Do not be concerned if the battery packs are inadvertently charged more than once or kept

on the charger for a long period of time. The batteries cannot be overcharged. If the battery pack

is in the battery pack charger and the battery pack is fully charged, the charger will terminate the

recharging process. The charger having no orange light when the charging is complete will

indicate this termination. Additional replacement battery packs are available by contacting

Biomet.

Button Functions

ALARM ON/OFF BUTTON

The Biomet

SpinalPak

located below the LCD display enables or disables the audible alarm. During an alarm condition,

depressing the button quickly (0.5 seconds) will temporarily disable the audible alarm. Depressing the

button for a longer period of time (3 seconds) will toggle the audible alarm between enabled and dis-

abled. Patients should be advised to leave the audible alarm enabled as frequently as possible in order

to assure the fully prescribed treatment. A speaker symbol will be indicated on the LCD display when

Figure 7

the alarm is enabled.

LCD Symbol Descriptions and Instructions

The alarm defaults to audible alarm. Press the button below the display on the front of the stimulator

to silence the alarm. After silenced, the light will continue to flash and the display will indicate the

alarm condition.

Symbol/TEXT

Figure 8

Figure 9

Stimulator is activated as soon as a charged battery is inserted. The button

Condition

Instructions

Treating

Continue use.

Audible alarm

If beeping, depress the button

briefly to silence the alarm. Depress the

button approximately 3 seconds to

engage or disengage the audible alarm.

Low battery

Insert a charged battery pack.

Disconnection

Confirm that each electrode is properly

applied on the skin. See the electrode

pouch for instructions. Confirm that the

lead wire is attached properly. Replace

the lead wire if necessary.

System error

Error in the stimulator –

Contact Biomet for assistance.

Stimulator is

Stimulator will not treat until USB

connected to

cable is disconnected

a PC

End of operation

Contact Biomet