EasyPro Vianti Falls HB11KEX Manuale di installazione - Pagina 2

Sfoglia online o scarica il pdf Manuale di installazione per Fontana da esterno EasyPro Vianti Falls HB11KEX. EasyPro Vianti Falls HB11KEX 4.

Stampa la pagina

Determine the

placement of

the Vianti Falls

system. Prepare

the base for

the 24" x 29

basin by properly

compacting

and leveling the

area. The Vianti

Falls spillway

is designed

to be placed

approximately

12" to 30" above the basin. The center of the

spillway and the basin must be aligned. The

spillway must be positioned in the wall to allow

for the lip to protrude past the wall at least

" (assuming the wall is plumb). This is to

ensure water will land in the 6" x 19" splash mat

included with the basin.

When building

the block wall,

a section of wall

must be left out

to accommodate

the plumbing and

electrical cord for the

pump.

Once the spillway

placement has

been determined in the

block wall, the block

will need to be cut to

allow for the plumbing

connections on the

back of the spillway.

Use appropriate tools

and extreme care when

cutting block. Consult

block manufacturer recommendations for

properly cutting block being used.

If the

lighting

option is

purchased

the LED light

strip can be fitted into the

back of the spillway. There are brackets on the

ends of the light bars with holes in them.

These brackets are for other applications.

The LED light bar should fit snuggly into the

back of the spillway. If necessary, a small

amount of silicone can be used as an adhesive

to hold the bar in place.

Splash

Mat

Hole for

Plumbing

and Pump

Power Cord

5 The block that

goes around the

spillway will need

to be cut to ensure

proper leveling and

look of the spillway

in the wall. The type

of block being used

will determined the

methods used. A lentil

may be required for longer spillways or in walls

that would require additional weight bearing

support. Consult a qualified professional for

specific installation requirements and codes.

The spillway should be "dry fit" to ensure the

spillway is level from side to side and front to back.

Once the spillway

is level and "dry fit"

the plumbing can now

be fitted. Use the 1"

PVC male adaptor and

the fittings provided

to connect spillway to

the flexible PVC pipe.

Wrap the threads of the

PVC male adaptor with

Teflon tape and thread into the spillway inlet(s).

Determine the placement of additional fittings

(elbows, tees, and extra pipe). Cut and glue all

the pieces together to fit the application.

The cord for the

LED light strip can

be tucked into the

notch in the spillway.

A dab of silicone

should be used to seal

the notch on opposing

side. Tuck the cord

between the blocks to run the cord to the power

source.

Run the 1" black

flexible PVC through

the hole previously

provided in the block

wall. Carefully measure

and cut PVC pipe to

proper length. Take

extra care to verify the

spillway has remained

in its level position

while measuring and cutting the pipe.