EasyPro Eco-Clear EC2600U Istruzioni per l'uso, sicurezza e garanzia - Pagina 5
Sfoglia online o scarica il pdf Istruzioni per l'uso, sicurezza e garanzia per Sistemi di filtrazione dell'acqua EasyPro Eco-Clear EC2600U. EasyPro Eco-Clear EC2600U 8. Eco-clear pressurized filters
Anche per EasyPro Eco-Clear EC2600U: Istruzioni per l'uso, sicurezza e garanzia (12 pagine)
UV Lamp and Quartz Sleeve Replacement – EC1300U
For units with UV lights it is recommended that a new lamp be installed after 12 months of
use. While the light might still turn on, the effectiveness of the UV light diminishes over time.
A glow from the clear section on the top indicates that the UV light is in use. Quartz sleeves
are typically long lasting and only require replacement if they break or develop a leak due to
the age of the seals.
UV Lamp Replacement
1. Unplug the UV unit and the pump.
2. Remove the six screws from around the top of the filter.
Take care not to lose any of the screws during this
process.
3. Remove the circular retaining ring and the top cover.
4. Remove the two screws and the plastic retainer clip that
holds the cord in place.
5. Unscrew the clear plastic UV lamp connector nut and
carefully remove from housing.
6. Remove the old UV lamp.
7. Carefully remove the black stabilizing protector on the end
of the bulb.
8. Do not touch the new bulb with your fingers. The oil from
your skin can cause pre-mature failure of the lamp.
9. Hold the new 9 watt lamp with a glove or clean cloth and
plug into the UV housing. Transfer the black stabilizing
protector unit to the new lamp.
10. Carefully slide the new lamp into the sleeve and screw
the connector back into place.
11. Reattach the cord retainer clip with the two screws.
12. Line up the cord properly in the housing and replace the
top cover and circular retaining ring. Secure with the six
screws.
13. Return the unit back to service.
UV Quartz Sleeve Replacement
1. Unplug the UV unit and the pump.
2. Loosen the locking nut that secures the outlet tubing
connector to the filter and remove it from the lid. Be sure
not to lose the gaskets that seal the connector to the
filter.
3. Remove the six screws from around the top of the filter.
Take care not to lose any of the screws during this
process.
4. Remove the circular retaining ring and the top cover.
5
Step 2
Step 4
Step 5
Step 9