Dickert E19 Istruzioni per il montaggio e il funzionamento - Pagina 8
Sfoglia online o scarica il pdf Istruzioni per il montaggio e il funzionamento per Automazione domestica Dickert E19. Dickert E19 8. Wireless receiver
Stampa la paginaReceiver E19
8 Declaration of Conformity
Dickert Electronic GmbH declares with complete responsibility, that the product meets the
regulations of Directive 1999/5/EC of the Council of the European Union. The complete text
of the Declaration of Conformity can be found on the website www.Dickert.com under
"Download".
9 Environmental protection / Disposal
The receiver does not contain any integrated batteries. Solely ROHS-conforming components
are used. Properly dispose of old and defective appliances and device parts in a collecting
point! Do not put them in domestic waste!
10 Troubleshooting
Errors
LED remains off on
the socket receiver
during transmitter
activation.
LED on the wireless
socket goes on with
transmitter activation,
but the "consumer"
does not react.
The "consumer" al-
ways goes off again
automatically after a
specific time.
11 Technical data
The operation of the control system is only allowed according to these specifications / data!
Receiving frequency: 433.92 MHz/AM or 868.30 MHz/AM (see imprint)
Coding:
Antenna:
Operating voltage:
Power consumption: <0.5W (standby operation)
Output:
Switch off timer:
Operating
temperature:
Dimensions:
Weight:
8 / 8
Possible causes
Battery in the transmitter is
empty.
Transmitter not taught.
Transmitter has incorrect cod-
ing schematic.
No power on the socket.
Transmitter faulty.
Socket receiver faulty.
Consumer possibly switched
off?
"Consumer" faulty.
Check whether the LED on the
wireless socket blinks when it is
switched on. If yes, the timer
mode was accidentally activat-
ed.
12 bit, 18 bit or Keeloq, self-teaching, max. 13 codes (transmitter keys) can be
taught
integrated (no ext. antenna required)
230 V, ± 10 % 50 Hz
max. 1000 W active load, 500 W lamp load, internal fuse (T5A)
programmable from 1s to approx. programmierb18 h, in 1s intervals
-20° C to +35° C at 20 % to 90 % rel. humidity, only indoor installation allowed.
approx. 96 mm x 64 mm x 49 mm (L x W x H) housing ABS, IP 20, self-extinguishing
approx. 155 g
Comments / Actions
Check / replace battery.
Teach transmitter.
Delete all transmitters and teach again.
Check mains fuse (circuit breaker).
Replace transmitter.
Replace receiver.
Check and switch on if necessary.
Check whether the "consumer" functions if it is
run directly from mains. If yes, replace the wire-
less socket.
Delete timer.
28506100_E19_EN_2012-08-07_EN.docx