Alpha Communications VMH25WH Series Manuale di istruzioni per l'installazione e l'uso

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione e l'uso per Sistema interfonico Alpha Communications VMH25WH Series. Alpha Communications VMH25WH Series 8.

Stampa la pagina

VMH25WH Video

Monitor Station (shown)

APPLICATION

The VMH25 series video-intercom system allows a

number of VMH25 series inside monitor+handset sta-

tions to communicate with one or more door entry stations

with (or without) a built-in camera. When used as a door

entry video-intercom system, the VMH25WH can view

the caller, speak with the caller, and activate an electric

door release (if required).

PROCEDURE

1. Read installation instructions for each unit to deter-

mine equipment location and installation method.

2. Install housings and wiring.

3. Install equipment.

4. Check wiring and connect. Observe all local

and national electrical codes.

5. Apply power and check system operation.

VMH25WH Series (Residential Type)

Video-Intercom Installation and Use

Instructions, used with the NH200A

System Intercom Amplifier Unit

HOUSING INSTALLATION AND

EQUIPMENT LOCATION

INSIDE MONITOR+HANDSET STATION(s)

Locate stations where needed at convenient speaking and

viewing height, about 4.5 feet (137 cm) from the finished

floor. Unit can be secured directly to the finished wall

surface or can be mounted over a single gang electrical

'gem' box or single gang electrical plaster ring.

DOOR ENTRY STATION(s)

Locate door entry station(s) at a convenient speaking (and

viewing) location at the building entry location(s). NOTE:

For best picture (video) quality DO NOT POINT

CAMERA INTO DIRECT SUNLIGHT!!!

SYSTEM TRANSFORMER(s)

The SS146 and SS106 system transformers should be

connected to accessible sources of 117 VAC, preferably

within 50' (15 meters) of the VRU system power supply

unit(s), but no closer than 3 feet (1 meter).

ELECTRIC DOOR OPENER (OPTIONAL)

The DO-001 (or equivalent 16VAC type) electric door

release is installed in the door jamb in place of the regular

door strike plate. It can be electrically operated by the

VMH25WH video monitor+handset station(s).

WIRING

INSIDE HANDSET STATIONS

Run 4 conductor #22AWG (common), RG59/U (com-

mon) and 1 conductor #22AWG (selective) cable from

video monitor+handset to video monitor+handset to the

central equipment location (where the VRU and NH200A

units are found). Run 2 conductor #18AWG from each

video monitor+handset directly to the corresponding VRU

power supply unit. Additional cables may be used to serve

other monitors on other risers (lines). Cables may be

straight or twisted pair type and may be solid or stranded

conductors. Depending upon additional system options

and/or functions you may need to run additional wires.

Please consult the factory for more information. RG59/U

coax cable must be good quality, ALL COPPER, with

minimum 95% copper braiding. As with all systems, we

recommend running some spare wires, for future use.

Route cable away from AC power wiring, transformers,

AWD067

Rev. 2 (03/03)