dicodes Dani Box Micro Manuale - Pagina 6

Sfoglia online o scarica il pdf Manuale per Sigarette elettroniche dicodes Dani Box Micro. dicodes Dani Box Micro 18.

05 Main Menu (Page 2)

The Temperature Up/Down menu sets the setpoint for the coil temperature during vaping. The temperature

setpoint can be selected from 120°C to 280°C (250°F- 540°F) in steps of 5°C (10°F). To achieve a high precision

temperature control, a correctly performed reference measurement (TempCal Init) is mandatory, see next item.

The temperature calibration measures the coil resistance at room temperature (20°C) as the reference

for temperature controlled vaping. This, together with the wire's temperature coefficient enables the device

to calculate the coil's temperature. The calibration must be confirmed in a second step to avoid accidential

activation. After confirmation the display shows "process" until the calibration is completed. It is extremely

important to understand, that, if the calibration is performed at a temperature other than 20°C, the control

will regulate a constant temperature, but with an offset deviation. So take the ambient temperature during

the temperature adjustment into account. Similiar, if a wrong temperature coefficient was adjusted, the

actual temperature might deviate dramatically from the set-point (here it is a factor and not an offset).

Always perform a calibration, when a new atomizer is attached, even if it is made from the same coil

material.

Note that the display will be continously updated, if the plus or minus button is kept pressed after

the values have been highlighted (or inverted). This can help during problem diagnoses .

In TC-mode, if the display does not show 20°C after calibration, even with a cooled down atomizer, we

recommed to perform the calibration again.

Note that for coils with very low resistance, like Nickel-coils, or with low temperature coefficient, like

stainless steel coils, a slight mechanical rearrangement (tightening the atomizer) can lead to drastical

changes in the temperature control due to the change of contact resistances. We therefore recommend

to use other than Nickel coils, e.g. The NiFe30 (RESISTHERM) wire from dicodes.

Also note, that when the device shows very high or very low temperatures the measured resistance

deviates a lot from the stored calibration value. This is not a fault of the mod. Check the contacts and

atomizer connection, then.

Setting the Temperature

This menu item is

only available and displayed if temperature controlled

vaping is selected

(see Heater-Control menu item below). So the menu

structure adapts to the selected operation mode.

Manual Coil Temperature Calibration

This Menu item is

only displayed if temperature controlled vaping is

(see Heater Control menu item below). For the use of temperature

selected

controlled vaping, the calibration measurement is a very important part of it.

Coil Resistance and Coil Temperature

This is a display only menu item. The coil resistance is displayed in a

range from 0.00 to 9.90 Ohms. If temperature controlled vaping is

selected, the measured/calculated coil temperature is also displayed,

if not, the display shows T ---.