EPCO 2418 Manuale - Pagina 3
Sfoglia online o scarica il pdf Manuale per Spazzaneve EPCO 2418. EPCO 2418 8. 48" snowblower for epco power king
Stampa la paginaSPECIAL INSTRUCTIONS FOR MOUNTING ON
1980 MODEL TRACTORS (after serial # 52589)
This 48
11
Snowblower incorporates parts and features that allows it to be
mounted on 1973 through 1979 model Power King tractors (except Jim Dandy
and 1612 models), and on 1980 models with a revised hydraulic lift system
(after serial number 52589).
For tractors with serial numbers prior to this, the assembly instructions and
parts illustrations as shown on pages 1 through 6 of the Operators Manual are
correct.
If this Snowblower is to be used on a 1980 model, substitute the
following procedure for assembling the lift link (paragraph
6,
page 1) and refer
to the illustration on the opposite side of this sheet in place of page 3.
A separate LIFT LINK ROD (Item 58) must be attached to the
LIFT WELDMENT (Item 5) at the point indicated by the letter
"A", using SCREW, 7/16" -20 NF x 1-1/4" long HHC (Item 28)
and NUT, 7/16 - 20NF Hex Lock (Item 19). The other end of the
LIFT LINK ROD (Item 58) should be attached to the Lift Arm on
the tractor with BOLT, 7 /16" x 2" long blank (Item 23) and a #9
large Quick Change KEY (Item 34).
NOTE: Only part
number 11-2550 has been added. The following part
numbers will NOT be required if the Snowblower is to be mounted on 1980
model tractors:
03-2102
FITTING
Grease 1
I
4" -28 short
2
15-0505
BRACKET
Lift Link
11
50-4701
LINK
46" Universal Lift
15
83-0024
SPRING
Compression 1" long
16
83-0124
SPRING
Compression 6" long
23
84-1111
BOLT
7 /16" x 2" long blank
24
84-1121
BOLT
7 /16" x 3" long blank
31
84-3060
WASHER
7 /16" SAE Flat
32
84-3070
WASHER
3/4" SAE Flat
34
84-4031
KEY
#9 large Quick Change
98-7105-1
1M879