Accuglide EzTilt Istruzioni - Pagina 2
Sfoglia online o scarica il pdf Istruzioni per Arredamento per interni Accuglide EzTilt. Accuglide EzTilt 4.
Stampa la pagina4) Stack the 2nd layer:
Place the 2nd layer as depicted in figure 2.
Refer to the material list below.
Material List
A. 36 x 60" (full sheet)
B. 35 x 60"
C. 15 3/4 x 35"
D. 15 3/4 x 36"
Joint Overlap: Figure 3
Layer 2 pieces should overlap on all interior
seams by one inch
5) Prepare for Drilling:
Clamp a wood 2x4 or 12.6' tracks over
the center seam to lock all sheets to-
gether (I.)
Clamp another wood block (H.) on the
top center to keep the sheets in place
while drilling (Depicted Figure 3)
6) Drill Holes/ secure sheets:
Drill four corner holes in all sheets and
start the provided elevator bolts on the
corners. Do not tighten.
7) Drill remaining field holes/ place hard-
ware:
Drill holes from the back of the table
using a hammer drill and a masonry drill
bit. Place the elevator bolts in the holes
from the front of table and set the car-
riage heads into the HardieBacker with a
large hammer.
8) Bolt down all hardware:
Start the 1/4" washers and 7/16" nuts
on the back of table . Use an impact
screw gun or ratchet wrench to tighten.
Start with the center bolts and work
your way to the out side. Torque the
bolts sufficiently making sure the eleva-
tor bolt heads are set as flat as possible
on the top of the table. Do not over
tighten.
9) Remove all support blocks and tilt table
to horizontal position.
Figure 2: 2nd Layer
A.
B.
Figure 3: Joint Overlap
Layer 1 seam
Layer 2 seam
1" overlap
Figure 3: Securing Sheets for Drilling
I.
D.
A.
C.
B.
H.