DieHard 200.71233 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Caricabatterie DieHard 200.71233. DieHard 200.71233 15. Battery charger 50/1512 amp manual; engine starter with battery tester and air compressor 225/125 amp
Anche per DieHard 200.71233: Manuale d'uso (15 pagine)

Stampa la pagina

Axle Assembly

(continued)

Place the charger on its side. Place one end of each

bracket into slot, then place the axle assembly under

each bracket. Fasten the other side of each bracket

using the two, 10-32 thread cutting screws provided.

Handle:

Turn the charger right side up onto its foot and wheels.

Remove the two top screws from each side of the

charger. Align the handle so the screw holes are

aligned with the screw holes on each side of the wheel

charger. Attach handle using the same screws.

Plugging it in

WARNING

Electrical Shock Hazard

Be sure that power cord fits properly into outlet.

If not, have a qualified technician install a proper

outlet. Never alter the AC cord or plug provided.

Improper connection can result in electrical shock.

Your charger should be grounded to reduce the

risk of electrical shock.

Your charger is equipped with an electrical cord that

has an equipment grounding conductor and a ground-

ing plug designed to be used on a 120 volt circuit. The

plug must be plugged into an outlet that has been

properly installed and grounded in accordance with all

local codes and ordinances.