EPHESUS All Field 750 Manuale di istruzioni per l'installazione - Pagina 12
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Attrezzature per DJ EPHESUS All Field 750. EPHESUS All Field 750 16. All field led luminaire
Stampa la paginaInstallation Instructions - All Field LED Luminaire
1.
Insert the laser or tube into the aiming mount and tighten the holding screw.
2.
Insert the aiming mount onto the fixture aiming pin until it is fully seated. Aiming mount must be tight against the fixture
because any movement or wiggle in the mount will cause aiming to be inaccurate.
Set
Screw
Hex
Screw
Figure 10. Aiming
3.
Slightly loosen the fixture aiming screws just enough to allow the fixture to rotate and tilt.
4.
Turn on the laser and aim the fixture by targeting the green laser dot at the aiming point. If aiming tube is used, look
through tube and adjust fixture until aiming point is centered in view through tube. Refer to photometrics or project
installation drawings for aiming point coordinates.
N
otee:
After targeting the aiming point with the laser, turn off the laser to conserve battery life.
12
EATON
MN507001EN
Aiming Laser or Tubing
Hardware
Side Set screw
Side Hex screw
Mounting bolt/nut
Installation instructions rev 170117
Mounting Hardware
Torque Value
35-75 in-lbs (4 to 8 N-m)
25-35 ft-lbs (34 to 47 N-m)
35-45 ft-lbs (47 to 61 N-m)