DieHard Portable Power 750 Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Avviamento a distanza DieHard Portable Power 750. DieHard Portable Power 750 8. 12v dc power source and jump starter
Anche per DieHard Portable Power 750: Manuale dell'operatore (8 pagine), Manuale dell'operatore (7 pagine)
Stampa la pagina
t2V
DC ELECTRICAL
DEVICE
EXAMPLE
RUN-TIME
CHART
Appliance
Type
Fluorescent
Lights,
Cellular
Phones
Radios,
Depth
Finders,
Fans
Camcorders,
DVD Players,
Spotlights
Electrical
Tools,
Bilge Pumps
Electric
Coolers
Air Compressors,
Car Vacuums
Estimated
Wattage
Estimated
Time*
4 Watts
20 Hours
9 Watts
14 Hours
15 Watts
8 Hours
24 Watts
5 Hours
48 Watts
2 Hours
80 Watts
I Hour
*NOTE:
Estimated
run-times.
Actual
time may vary. Times
are based
on the internal
battery
being fully charged.
USING
THE
BUILT-IN
LIGHT
1.
Position
the
750 on a flat,
stable
surface
near
the
intended
work
area.
2.
Turn the Light/Display
switch
to the
LIGHT
position.
The light will turn on
and illuminate
your work area.
NOTE: With afullycharged
internal
battery,
the built-in
light should
provide
18 to 30
hours of continuous
useful light, depending
on ambient
conditions.
3.
Turn
the
Light/Display
switch
to
the
OFF
position
when
work
is
completed.
4.
Charge
the 750 as soon as possible
after using the built-in
light.
LED
INDICATORS
To check
the
internal
battery's
status,
press the switch
on the front of the 750.
2.
The LED lights will indicate
as follows:
1.
A red light
indicates
a 50%
or less
charge
and you should
immediately
charge
the 750.
2.
A yellow
light indicates
a 50 to 75%
charge.
The
750
may
be
used,
but should
be charged
as soon
as
possible.
3.
A green
light
indicates
the internal
3.
battery
is fully charged.
CHARGING
THE
INTERNAL
BATTERY
This
Portable
Power
750 comes
with
a
sealed,
non-spillable
DieHard
mainte-
nance-free
lead-acid
battery.
This internal
battery
is specifically
designed
to deliver
high power jump-starting
as well as repeti-
tive deep cycling
performance.
To charge
the Portable
Power 750 internal
battery:
1.
Check
the internal
battery's
charge
level by pressing
the switch
marked
DISPLAY.
The internal
battery
status
LEDs will light.
NOTE:
Internal
battery
status
LEDs
are most accurate
when the Portable
Power
750 has been
disconnected
from all devices
and charging
sources
for at least 30 minutes.
Using
a proper
extension
cord,
connect
the cord
to the charge
plug
and then plug the cord into a properly
wired
and
live
110Vac/6OHz
wall
outlet.
CAUTION:
Operating
the Portable
Power 750 while the internal
battery
is
being charged
may cause permanent
damage
to the unit.
While
the
Portable
Power
750
is
charging,
the red "CHARGING"
LED
will
illuminate.
When
the
internal
battery
is fully
charged
the green
"FULU'
LED will illuminate.
Complete