Olympus PT-019 Manuale di istruzioni - Pagina 18

Sfoglia online o scarica il pdf Manuale di istruzioni per Camera Accessories Olympus PT-019. Olympus PT-019 38. Waterproof case

Set the mode dial.

After the digital camera has been loaded,

push down the mode dial of the Case from

the upper surface of the Case. Set it so that

the lower part of the mode dial on the inside

of the Case fits properly onto the upper part

of the mode dial of the digital camera itself.

Also, load the camera so that the power

switch of the digital camera fits into the

power switch lever notch on the inside of the

protector.

Advice • After setting the mode dial of the Case, set the power of the digital

camera to 'OFF', and before sealing the Case, operate the mode dial

and confirm that the mode of the digital camera is switched.

Before sealing the Case, insert the accessory silica gel bag (for

prevention of fogging) between the bottom of the camera and the

Case. Insert the bag with the glued longer side to the inside.

CAUTION

: • Insert the silica gel all the way at the specified location and

with the specified orientation. When the orientation is not

correct, the silica gel bag will be caught when the Case is

sealed and water leakage will be caused.

• Attempting to seal the Case with the bag inserted only part of

the way will cause the silica gel bag to get caught by the O-ring

and water leakage will occur.

• Once silica gel has been used, the moisture absorption

performance will be impaired. Always exchange the silica

gel when the Case is opened and closed.

Pay attention to the orientation.

E-17