Axminster AWDS12H Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Sander Axminster AWDS12H. Axminster AWDS12H 16. Hobby series 300mm disc sander

Specific to Sanding Machines

WARNING! THE SANDING DISC CANNOT BE DECLUTCHED

FROM THE BELT AND VICE VERSA, BOTH FUNCTIONS ARE

ACTIVE WHEN THE MACHINE IS RUNNING. REMEMBER THIS,

AND DO NOT LEAVE LOOSE OBJECTS OF ANY DESCRIPTION,

ON THE MACHINE IF IT IS GOING TO BE USED.

Once the sander is mounted, carry out any setting operations, (mitre, tilt..?), and remove all tools

used in the setting operations (if any) and place safely out of the way. If you are working long

lengths of material arrange for extra support beyond the boundary of the machine, and check you

have sufficient room to manoeuvre the material through all the operations you will wish to carry

out.

It is good practice to leave the machine unplugged until work is about to commence, also make

sure to unplug the machine when it is not in use. Always disconnect by pulling on the plug body

and not the cable.

After fitting a new sanding disc, it is good practice to lightly sand across the left side of the disc

with a reasonable sized (20mm x 50mm) piece of timber to make sure the sanding disc is

correctly 'seated' on the disc. The sanding action will press the sanding disc firmly back against

the disc itself.

It is not good practice to wear gloves whilst sanding as one tends to lose the 'feel' of the

workpiece/sander contact, but obviously this removes the safety barrier between your fingers

and the sanding surface. Remain focused and exercise caution whilst sanding.

DO NOT sand very small pieces of work with bare hands; try to construct some form of holder.

MAKE SURE you are comfortable before you start work, balanced, not reaching etc.

If the work you are carrying out is liable to generate excessive grit or dust or chips, wear the

appropriate safety clothing, goggles, masks etc., If the work operation appears to be excessively

noisy, wear ear-defenders. If you wear your hair in a long style, wearing a cap, safety helmet,

hairnet, even a sweatband, will minimise the possibility of your hair being caught up in the

rotating parts of the machine, likewise, consideration should be given to the removal of rings and

wristwatches, if these are liable to be a 'snag' hazard.

DO NOT work with cutting/abrasive tools of any description if you are tired, your attention is

wandering or you are being subjected to distraction. A deep graze, a lost fingertip or worse, is

not worth it!

DO NOT use the machine within the designated safety areas of flammable liquid stores or in

areas where there may be volatile gases. There are very expensive, very specialised machines for

working in these areas, THIS IS NOT ONE OF THEM.

CHECK that sanding surfaces are still sufficiently abrasive to carry out the work you intend.

Sanding belt cleaning sticks are an efficient method of prolonging the life of the belts and discs,

and will also maintain their operating performance.