Axminster AW12BM Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Trapano Axminster AW12BM. Axminster AW12BM 20. 12mm bench morticer

Initial Assembly of the Machine (Continued)

2) Locate the Accessory tray, the small 'P' clip and the three small panhead screws. Locate the 3

No. threaded holes in the rear upper left side of the headbox. Snap the 'P' clip on the cable, tidy'

the mains cable away from the front of the machine, and secure into the most forward threaded

hole. Offer up the accessory tray and secure using the remaining two panhead screws, into the

threaded holes.

3) Locate the backfence and its associated components. Fit the lift and shift clamping handle into

the back fence mounting block, leave the housing clear to fit the main mounting bar of the back

fence. Fit the large spring over the main mounting bar, introduce the bar into the mounting block

and push home, put the spring under some tension and tighten down the clamping handle.

Located the 'fine adjust' assembly over the main bar and secure in place by tightening the socket

grubscrew. Turn the adjusting bolt until the bolt is in contact with the mounting block. Unlocking

the clamping lever handle should enable the back fence to be adjusted back and forth using the

adjusting bolt 'with' or 'against' the tension in the spring.

4) Locate the handle and the grip sleeve, fit the sleeve over the handle. (If it is difficult to slide on,

try lubricating with a small amount of washing up liquid. Locate the small spring and the large

headed screw. Place the handle over the rise and fall shaft, fit the spring over the large head

screw shaft and screw into the end of the rise and fall shaft. The spring pressure should be

enough to keep the castellated dogs of the handle and the rise and fall shaft together under

normal operation, but allow the dogs to be disengaged to re-position the handle. Exercise the

headbox up and down and check everything works satisfactorily.

5) Locate the hold down yoke, fit over the rod fitted upright in the backfence casting,

secure in place using the socket grubscrew. Locate the dust extraction pipe and the short

caphead bolt. The pipe is located onto the hold down yoke using the bolt into a pre-threaded

hole in the top of the left arm of the hold down yoke.

Axminster No.

Rating:

Motor:

Chisel Stroke:

Centre of Chisel to Back Fence:

Max Height of Timber with 12.7mm Chisel and Bit:

Max Chisel Size Softwood:

Max Chisel Size Hardwood:

Overall L x W x H:

Weight

(100081) AW12BM

Light Trade

240V a.c. 50 Hz 370W

110mm

95mm

120mm

12.7mm

350 x 350 x 600mm

25kg