Axminster H20002 Manuale - Pagina 5

Sfoglia online o scarica il pdf Manuale per Utensile elettrico Axminster H20002. Axminster H20002 6. Fixed drill press

Tool illustration and Parts description

Drilling holes for

Centre Drilling edges

Extend the guide rods below the base and clamp in position, straddle the edge of the work

piece and turn the base so that the guide rods are pressed against the opposite sides of the

work piece, hold in position and drill

Fig 7

door hinges

Fig 8

Guide rods

Stand the base on a flat surface, fit the two guide rods (B) into the two housings on either side of

the base, making sure the return springs and the depth stop clamp remain on the rods, and

clamp in position using the guide rod clamps. Ensure that the drill mounting bridge positioning

clamp (D) and the depth stop clamp (E) are slackened off, and check the operation of the

assembly by depressing the drill mounting bridge several times by hand, and ensuring that the

rise and fall of the mounting is smooth and unhindered. Inspect the 'V' grooved base insert and

check that there is no 'flashing' on the underside of the moulding that would prevent the insert

sitting flat on the work surface. If there is, carefully pare off the 'flashing' with a sharp knife or

gently rub the insert over a piece of abrasive paper (laid flat on the work surface) until all traces

of the 'flashing' have been removed.

N.B There are 2 sets of 4 No. holes ( 4 Bolt holes, 4 Countersunk Screw/Bolt holes) in the base of

the device to allow the drill press to be fixed or held in position. Where possible, it is

recommended that the device and the work piece are always held securely during drilling

operations.

The side steady handle can be fixed on either side of the device, as required.

Fig 3

Clamping screw 'D'

Fig 4

Assembly

Clamping screw 'E'

Bolts 'F'

Depth required