Axminster SIEG G1 Engineer Series Manuale d'uso - Pagina 11
Sfoglia online o scarica il pdf Manuale d'uso per Utensile elettrico Axminster SIEG G1 Engineer Series. Axminster SIEG G1 Engineer Series 16. Powered hacksaw
Anche per Axminster SIEG G1 Engineer Series: Manuale d'uso (16 pagine)
Stampa la pagina
This is a very simple machine to operate, there are no
choices of speeds or down-feed settings to select.
The arm has a supporting gas strut to take some of
the weight of the arm and allow the arm to descend
in a controlled fashion.
When you raise the arm, there is a latching arm that
will drop into place to support the arm in the raised
position. (See Fig A)
When you wish to begin cutting, lower the arm onto
the material and press the ON (green) button on the
switch. (See Fig C)
Fig A
Latching arm
Operation of the Powered Hacksaw
DO NOT lean on the arm to increase the cutting rate.
Use the length stop assembly to create identical
lengths of materials. (See Fig B)
The machine should switch off automatically when
the cut is completed, if the machine does not switch
off, press the STOP (red) button manually.
Disconnect the power supply and adjust the stop
actuator mounted on the lower part of the arm so
that it pushes the stop button down further.
Fig B
Length stop assembly
11
Fig C
Lower the arm onto the
material ready for cutting