Axminster ZQJ4125K Manuale - Pagina 13

Sfoglia online o scarica il pdf Manuale per Utensile elettrico Axminster ZQJ4125K. Axminster ZQJ4125K 18.

DRILL PRESS MANUAL

Figure 14

Figure 15.

Depth Stop

Your drill press comes with a depth stop adjustment for use when drilling.

This is a combination of a cast angle bracket & cover, which fits in a housing machined in

the drillhead, (it mounts the bearing pocket for the end of the splined feed shaft and the

return spring), the 'angle arm' of the bracket protudes out from the drillhead parallel with

the base. There is a clearance hole bored through this arm. There is a round plate casting

with a triangular extrusion clamped around the outer sleeve of the quill. Within the apex of

this triangle a threaded hole mounts the depth stop control rod, which also feeds up

through the clearance hole in the angle arm bracket. This rod is originally threaded, which

allows it to be screwed through the hole in the plate and secured in position with a lock nut.

The greater part of the rod over the top of the mounting plate has been milled flat (less than

radius depth) to enable a scale decal to be fitted. A nut is fitted over to the depth stop rod

below the angle arm bracket (to control the 'lift' of the quill) and a nut and a lock nut fitted

above the angle arm bracket to limit the 'plunge'. The graduated scale can be read over the

top of the angle arm bracket and will allow the depth of the drill plunge to be measured, or

set.

Which as shown in Figure 15.

Table Adjustment

The table can be adjusted for height, rotation and angle.

1. Loosen the support bracket lock knob. Turn the table hand crank to lift or lower the

table as shown in Figure 16.

2. Always lock the support bracket in place before operating the machine.

Adjust rotation:

1. Loosen the lock handle located under the table as shown in Figure 17. Rotate the

table the desired amount.

2. Always lock the table rotation in place before operating the machine.

Adjust angle:

We reserve the right of the amendment addition and deletion of the

specifications, explanatory wording, etc. printed in this manual

PDF 文件使用 "pdfFactory Pro" 试用版本创建