Axminster Craft AC150BG Manuale di istruzioni originale - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni originale per Smerigliatrice Axminster Craft AC150BG. Axminster Craft AC150BG 16.

Stampa la pagina

General Instructions for 230V Machines

The following will enable you to observe good working

practices, keep yourself and fellow workers safe and

maintain your tools and equipment in good working order.

WARNING!! KEEP TOOLS AND

EQUIPMENT OUT OF REACH OF

YOUNG CHILDREN

KEEP WORK AREA AS

UNCLUTTERED AS IS PRACTICAL.

UNDER NO CIRCUMSTANCES

SHOULD CHILDREN BE ALLOWED

IN WORK AREAS.

Mains Powered Tools

• Tools are supplied with an attached 13 Amp plug.

• Inspect the cable and plug to ensure that neither are

damaged. Repair if necessary by a suitably

qualified person.

• Do not use when or where it is liable to get wet.

Workplace

• Do not use 230V a.c. powered tools anywhere

within a site area that is flooded.

• Keep machine clean.

Specific Safety Precautions for Grinding Machines

1. Do not operate your machine until it is completely

assembled and installed according to the instructions.

2. If you are not familiar with the operation of grinding

machines obtain advice from your supervisor or instructor

or another qualified person.

3. Only use grinding wheels or attachments rated higher

than 3600 rpm with a 5/8"(16mm) arbor on this machine.

4. Never use a chipped or cracked wheel. Always inspect

each wheel before mounting it on the grinder. If during

inspection you discover a damaged grinding wheel, replace

it immediately.

5. Do not over tighten wheel nuts.

• Leave machine unplugged until work is about to

commence.

• Always disconnect by pulling on the plug body

and not the cable.

•

Carry out a final check e.g. check the cutting tool

is securely tightened in the machine and the

correct speed and function set.

•

Ensure you are comfortable before you start work,

balanced, not reaching etc.

• Wear appropriate safety clothing, goggles, gloves,

masks etc. Wear ear defenders at all times.

• If you have long hair wear a hair net or helmet to prevent

it being caught up in the rotating parts of the machine.

• Consideration should be given to the removal of rings and

wristwatches.

• Consideration should also be given to non-slip

footwear etc.

• If another person is to use the machine, ensure they are

suitably qualified to use it.

• Do not use the machine if you are tired or distracted.

• Do not use this machine within the designated safety

areas of flammable liquid stores or in areas where there

may be volatile gases.

• Check cutters are correct type and size, are

undamaged and are kept clean and sharp, this will

maintain their operating performance and lessen the

loading on the machine.

• OBSERVE.... make sure you know what is

happening around you and USE YOUR COMMON SENSE.

6. Always maintain a distance of 2mm or less between the

wheel and the tool rest. Adjust the tool rests as the wheels

decrease in size.

7. Ensure the tool rests are tightened so they cannot move

while in use.

8. Never grind on a cold wheel. The grinder should always

be run for at least one minute before applying work to it.

9. Never grind on the side of the wheel. Always grind on

the face of the wheel only.

10. Never apply coolant directly to a grinding wheel, it may

cause the bonding to fail. If the work piece becomes hot,

dip it into a water pot to cool it down.