Cineo Quantum c80 Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzature per DJ Cineo Quantum c80. Cineo Quantum c80 13. Ultimate creative lighting tool

The DMX pin wiring is as follows:

• Pin 1: Signal Common

• Pin 2: Data –

• Pin 3: Data +

• Pin 4: Spare

• Pin 5: Spare

Wireless DMX Control

The Qc80 built-in wireless receiver runs on CRMX / Lumen Radio protocol which can receive signals from

CRMX and some WDMX transmitters. Please note that each fixture can only be linked to a single network

at a time, and maintains the network ID of its previous linking. Therefore, the fixture's linking data must be

cleared prior to linking to a new network.

To unlink Qc80 fixture, follow these steps:

1. Push and hold the Red control knob on the control panel for 3 seconds. Release.

2. Rotate the Red knob until the Status Display shows RADIO highlighted. Push to select.

3. Make sure the UNLINK menu option is highlighted, and select. The Control Display will flash for 10

seconds, and the Radio is ready for linking to a transmitter, clearing the network memory in the fixture.

To link to a new transmitter, make sure the fixture is unlinked, in DMX mode and the DMX addresses are

set.

If the unit is in DMX Mode and no cable is inserted in the DMX IN port, Wireless DMX is automatically

activated and the unit can now be controlled on a linked wireless DMX network. When the unit is ready

to receive a signal from a transmitter but is not yet linked, the CONTROL screen will flash "DMX NONE. "

Once the connection is made the CONTROL Screen will change to "DMX WIFI" and can now be control

remotely.

Refer to your wireless DMX transmitter instructions for linking fixtures to a wireless network.

Third party wireless products can be used by plugging the third party wireless antenna into the DMX XLR

port. If power is needed for the antenna the powered USB port can provide such up to 500ma@ 5VDC. If

a third party wireless device, powered or non powered, is attached via the 5pin XLR port this connection

will take priority over the imbedded wireless receiver.

RDM Support

The Qc80 can remotely report unit information to an RDM controller attached via wired or wireless DMX.

The information provided includes the Unit ID and the firmware revision programmed into the unit. The

unit also supports the RDM Identify command, and will ask the fixture when an Identify command is

issued.

Remote programming of Mode, DMX address and Calibrate functions are supported. The fixture defaults

to a 4-address footprint for RDM auto-assign functions.