ARC Automate Manuale di istruzioni per la programmazione - Pagina 14
Sfoglia online o scarica il pdf Manuale di istruzioni per la programmazione per Telecomando ARC Automate. ARC Automate 16. 15 channel remote
Stampa la pagina
9
TROUBLE SHOOTING
Problem
Motor is not responding
Cannot set limits on a single
motor (multiple motors
respond)
Motor will not go down after
setting the top limit.
Motor will pair, but can not set
limits.
14 | Automate
Programming Instructions | 15 Channel Remote
™
Cause
Remote battery is discharged
Battery is inserted incorrectly
Radio interference / Shielding
Receiver distance is too far
from remote
Power failure
Incorrect motor wiring
Using channel 0 to adjust
motor limits
Top limit was set using the
DOWN and STOP buttons.
Switch is in a locked state.
Control must be unlocked
to set limits or perform any
multi-button functions.
Remedy
Replace battery
Check battery polarity
Ensure remote is positioned away
from metal objects and that aerial on
motor or receiver is kept straight and
away from metal.
Move remote to a closer position or
consider a repeater for improved
performance.
Check power supply to motor is
connected and active.
Check wiring is connected correctly
(refer to motor installation
instructions).
Always reserve an individual channel
for programming functions.
Reset the motor and begin
programming sequence again.
Remember that upper limit is to be
set using the UP and STOP buttons,
and the down limit is set using the
DOWN and STOP buttons.
Press and hold LOCK button for 5
seconds, until locked state changes.