ABB ACS 400 Manuale di installazione

Sfoglia online o scarica il pdf Manuale di installazione per Controllore ABB ACS 400. ABB ACS 400 4.

CHECK BOX CONTENTS: ACS 400, Manual, Mounting Template, Installation Guide, Clamp plates

CHECK INSTALLATION SITE: See Manual.

TOOLS NEEDED: Screwdrivers, Wire stripper, Tape measure, 4 pcs 5x12 mm screws, Drill

FROM MOTOR NAMEPLATE: Supply voltage, Nominal motor current, Nominal frequency, Nominal

speed, Nominal power, Cos

Note! This Installation Guide is only for setting the speed of a single motor.

Packing box lid contains wall mounting template.

Remove it from the box.

ACS 400 should ONLY be mounted vertically on a

smooth, solid surface, free from heat, damp and

condensation. Ensure minimum air flow gaps of 200 mm

above and below and 50 mm around sides of unit.

1. Using mounting template, mark fixing hole positions.

2. Drill the holes.

3. Screw in four screws or affix nuts and bolts

(depending on mounting surface).

Position ACS 400 onto fixings and securely tighten in

all four corners.

Note! Lift ACS 400 by its chassis and not by its cover.

Before Starting Installation

ENSURE MAINS SUPPLY TO INSTALLATION IS OFF.

ENSURE MOTOR IS SUITABLE FOR USE WITH ACS 400.

ACS 400 MUST BE INSTALLED BY A COMPETENT PERSON.

IF IN DOUBT DO NOT INSTALL.

Installation Guide

for product type ACS 400