Cintroclear UF 400 Manuale di istruzioni per l'installazione - Pagina 4
Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Sistemi di filtrazione dell'acqua Cintroclear UF 400. Cintroclear UF 400 9.
Stampa la paginaINSTALLATION OF THE CINTROCLEAR UF 400 WATER PURIFIER
Tools :
Your Cintroclear purifier can be connected very quickly and simply, all the hydraulic connections are carried
out using automatic push-in connectors that require no tools other than a cutter. Two other tools are required: a
screwdriver for mounting the purifier and a small drill fitted with a 14 mm drill bit for drilling the hole for installing
the pure water tap.
Positioning :
The purifier is usually positioned beneath the kitchen sink or in one of the nearby kitchen units, these places
are often the most simple to use. It may also be installed in any other position, as dictated by the layout of the
house: room next to the kitchen, cellar, laundry room, etc. The various accessories for connecting the water
supply and the small diameter of the inlet and outlet piping allow for many installation options. The purifier must
always be installed in a clean and easily accessible position that allows the meter to be read and maintenance
operations to be carried out simply.
IMPORTANT : for correct operation, the purifier must be installed and attached vertically. It must never
be operated when inclined or lying flat; this may give rise to operating problems.
Fixation :
The installation kit for your Cintroclear purifier contains two sets of fixing screws, allowing the unit to be
installed against a wall or in a kitchen unit for example. The shape of the attachment holes in the purifier
mounting plate allows it to be easily removed later for carrying out maintenance operations.
Piping:
Your Cintroclear purifier is equipped with automatic
connectors throughout. These connectors are very
simple to use and they are totally reliable. When cutting
the polyethylene pipes, take care to make clean, square
cuts without any burrs. Do not use any tool other than
the tube cutter, never use shears or cutting pliers,
the piping will not be cut cleanly and you risk
damaging the seal and causing leaks.
Attaching the pure water tap:
Position the components on the threaded tube : body
seal, rosace, plastic washer and rosace seal. Then
pass the threaded tube through the hole drilled
previously in the wash basin or work surface. Then
place the lower components on the threaded tube :
st/st washer, lock wascher, the nut, the internal
cylindrical reinforcement, the bicone and the nut (these
last 3 components are put on the blue outlet pipe) and
tighten down.
Generally it will seal when tightened on hard by hand.
Nevertheless, if this is not sufficient it may be tightened
down lightly with a tool. In all cases, stop tightening
once it is sealed.
4