Arcam P38 Manuale - Pagina 8

Sfoglia online o scarica il pdf Manuale per Amplificatore Arcam P38. Arcam P38 18. Integrated and power amplifiers
Anche per Arcam P38: Manuale (18 pagine)

Stampa la pagina

Confi guring your C31 pre-amplifi er

Introduction

The C31 allows you to customise various features of the amplifi er to fi t your system. Use this diagram

to help you navigate through the available confi guration options.

In the diagram below, the

symbols

The control knob is shown as

Adjusting listening settings

Normally, the display shows the current volume and the control knob is used

to adjust this.

Press

SELECT

to cycle through the menu items. When you have found the setting that you

wish to adjust (the setting is shown on the display), it can be adjusted by

using the control knob. Press

return to default (volume) mode, or press

setting.

Note that the menu will time-out after a short period of inactivity, with the

display reverting to the current volume.

The following items are available for adjustment:

Volume Resolution – There are three volume-display options to chose from:

'Standard', 'Fine' or 'Reference'. Standard and Fine represent different

levels of volume-control sensitivity; the Reference setting gives absolute

increments in 0.5dB steps.

Input Trims – Input trims are used to compensate for variations in

output levels of different source equipment. If, for example, your CD

player is louder at a given volume display value than other inputs, you

can attenuate it by using this setting so that it matches your other

components.

Use the source-select buttons to select the input you wish to adjust, then

the control knob to set (increase or decrease) the input volume for that

source.

Max. 'On' Volume – This can be used to limit the maximum volume the

amplifi er operates at when it is fi rst switched on: the C31 comes on at

the (reduced) "Max. On Volume" level if the last-used volume exceeds

this value.

If this item is set to 'Disabled', the C31 always comes on at the last used

volume, even if this is very loud.

Processor Mode – Processor mode enables you to fi x the gain (volume

setting) of your C31. The C31 (in combination with a power amp.) can

then be used to drive the front left and right speakers of a surround-

sound system, when fed from a separate processor. The volume of the

entire system can then be controlled using the processor.

Feed the sound from the processor into the

of the C31 to match the amplifi ers that drive your other loudspeakers.

Reset – this restores all amplifi er settings to their factory defaults.

C31/P35/P1

E-8

and

ENTER

SELECT

and

respectively.

once to enter the confi guration menu, then press it repeatedly

to store the change you have made and

ENTER

SELECT

buttons from the front panel are represented by the

again to move to the next

input, then set the gain

TAPE

��