Axxent AX 1400TS Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Axxent AX 1400TS. Axxent AX 1400TS 4. Professional power amplifier

user manual

output connectors, low Impedance

Above the 3 pin xlr input connectors are the dual binding posts that are

used for the low impedance output of the amplifier. These binding posts

are touch proofed according to international safety regulations.

The designation of the binding posts: 240W/4Ω (model AX1240TS) or

400 W/4 Ohm (model AX1400TS). The model 1121TS is equipped with an

Euro-bloc connector on the output. The designation beneath: 0, 50, 70,

100 V for the constant voltage outputs, alternatively you may use the "+"

and "–" terminals for low impedance loudspeakers down to 4 ohms.

You may operate the amplifiers with four ohm load and full power at all

times. Please note however, that in this case you may not use the con-

stant voltage outputs. It is important to know that combined power of

simultaneous use of both constant voltage and low impedance outputs

may not be higher than the r.m.s power of the amplifier. For example, if

you use an 8 ohm speaker at the low impedance output connector, you

will take approximately two thirds of the total available power and the

other third then may be used to drive 100 v loudspeaker lines.

input connectors

The amplifiers use fully balanced inputs for minimum interference. The

input is a three pin female xlr connector and the "send" xlr connector is

meant to route the input signal to additional amplifiers. All standard

microphone cables may be used to connect the amplifier. Inputs are

electronically balanced and have a nominal impedance of 20 kohms.

Model 1121TS is equipped with a Phoenix Euro-bloc on the INPUT. The

input is balanced and marked + and – for the polarity and ⊥ for ground.

amplifier cooling

Amplifier models AX1121TS, AX1240TS and AX-1400TS use convection

cooling. Heat transfer is by the rear heat sink. Because no fan is being

used to transfer heat, there is no operating noise at all.

CE Declaration of Conformity

axxent Products AX1121TS, AX1240TS, and AX1400TS fulfill the criteria of the EMC regulation 2004/108/EG and

especially therefore comply with EN61000-6-1 2007, electro-magnetic susceptibility for private use, commercial

use and light industrial applications according to table 2. Products AX1121TS, AX1240TS and AX1400TS fulfill

the criteria of the low voltage directive 2006/95/EG of December 12, 2006 regarding electrical

axxent e.K. • Technologiezentrum Herzbachtal • Zum Wartturm 15 • 63571 Gelnhausen

Fon: +49-6051-9165584 • Fax: 9165585 • [email protected] • www.axxent.de

models AX-1121TS / AX1240TS / AX 1400TS

equipment.